.0011 1/2 of an inch
One inch.
When I wire a panel, the outer insulation of the romex does not extend past the romex connector, after the actual conductors have been neatly shaped to the ground / neutral bar and the line has been brought to the breaker the insulation of the hot & neutral is then stripped exposing 1/4 inch of copper then landed.
Connect the black wire to the smooth wire. The ribbed wire is the identifier for the neutral wire which is connected to the shell of the lamp holder. The smooth wire connects to the center pin in the lamp holder. Using this configuration the hot wire is kept away from your fingers as far as possible when changing out the light bulb.
about 5 inches
Far enough away that no one can accidentally reach them from the window. Electrical transmission wires should never be touched, but they need to be brought in to a fuse or breaker box, usually in the basement for single dwellings or some closet for apartments.
The maximum distance to run electrical wire underground without compromising safety or efficiency depends on factors like wire size, voltage, and local building codes. In general, it is recommended to consult with a licensed electrician to determine the appropriate distance for your specific situation.
Are you asking about home electrical service? sevrice entrance cables need to be three feet away from a window
The maximum distance a 12 gauge electrical wire can run depends on the voltage and amperage of the circuit it is serving. In a typical residential circuit with 120 volts and 20 amperes, a 12 gauge wire can run up to 60 feet before voltage drop and overheating become concerns. It is always best to consult local electrical codes and standards for specific guidance on wire length limitations.
im not 100% positive but i think its 6inches
Two wire plug, front of trans, on the far driver sideTwo wire plug, front of trans, on the far driver side
It is an option on cars sold in the far north. If it has one there will be an electrical wire near the front of the car you plug into a 120 volt outlet.
hi, glad you asked. well if you follow the wire far enough into the edge of the roof, ther should be a clip to disconect it. good luck!