On a 2000 Ford Ranger :
With the engine cold the radiator should be filled to the seat for the
radiator cap and the engine coolant reservoir should be filled to the cold
mark
Remove the radiator cap and add it directly to the radiator. Then fill the overflow reservoir to the full mark.
The coolant level is checked at the coolant tank in the passenger front corner of the engine compartment . The coolant level should be up to the cold mark when the engine is cold . The radiator should be full so its covering the top plate .
No.
As long as it's not a full sized ranger, yes.
2000
If there are no schrader valves to bleed the system, remove the radiator cap, make sure the radiator is full of coolant, turn the heater controls to HOT, start the engine, watch for air bubbles escaping, keep the radiator full, and when you see no more air bubbles escaping, replace the cap. The system is now bled.
i need a full picture view for the removal and instillation for a radiator for a 1989 ford e150 van 5.0 engine
i have a 1990 ford ranger and my fule gauge always reads full, why?
Typical Ford
I have a 1995 ford ranger, and the ABS light comes on when the brake fluid is low. Check and make sure your brake fluid is full. If it is full then it could be a number of different things.
The check engine light on a 1999 Ford Ranger is between the full mark of the gas gauge and the left turn signal arrow
the overflow reservoir, it should have marks for full cold and hot