Having a head gasket replaced on a 2000 Amigo can be replaced but it can be hard depending on if the mechanic has the right instructions. Also, depending on the condition of the head gasket can depend on how hard it is replace the gasket.
It's not hard but time consuming.
replace head, head gasket, and head bolts.
how is it to replace fuel pump on 2000 Chevrolet truck
It is not hard, certainly no more than any large gasket. I have most success by 'gasket gooing' the gasket to pan, then holding pan up and inserting all bolts 2-3 turns first, then start doing up finger tight opposite sides, finally with wrench, still opposite sides.
need diagram of how to install pcm in a 2000 mitsbishi galant
Yes, it is a very involved project on a car with very little room under the hood.
yes sir. 98 and 99s share the same top.
I don't have the direct answer but I just had to replace mine. I went to my local auto parts store and bought a Haynes repair manual for $21 and it gave me step by step directions on how to replace the gasket. Seams like a tough job but its really not that hard, just remember were the bolts go and to clean everything before reassembling.
how hard is it to remove a flywheel on 2002 volvo s80
I have a mid size RV that's shaped like a van in the front. The intake was removed. Is it hard to put back on.
Sure if you plan on keeping the vehicle. As you did not say what make and model, hard to answer this intellegently. Weigh the cost of the repair with what the car is worth.
remove the 10mm bolts from the edges and clean all surfaces VERY CLEAN and replace gasket and then torque the bolts back not sure of the lbs to torque to good luck it is not hard to do