38 inches is standard, but if you have high ceilings, 44 is the norm.
It Is A High Wall Which You Go Up To Walk On It. The View Is Incredible!!
It Is A High Wall Which You Go Up To Walk On It. The View Is Incredible!!
You pedafile
John Wall went to Garner Magnet High School in Garner, North Carolina.
You go on a friend you want to do wall-to-wall with's profile page. Their wall should be there. Post a post that is your wall-to-wall post and send it to their wall. That's how to create a wall-to-wall.
Around the beginning of the level( You should be on a 2D level), you should go on one of the swings. Swing as high as you can and if you are in the right place, you should see a wall with boards, they signify you should wall kick on them, on the right. After wall kicking, you will see some star bits. Go higher, and you should the sound that tells you a star is near. Once you get to the top, you reach an area with some grass, the star is hovering over the grass.
you go into buy mode then you click on your painting which should still be on the thing that you painted it on and drag it to the wall and then its on the wall.
get on the grim reapers syth and go into the underworld on murderous jailer lane there should be a big black wall go up to the wall and cut your heart and eat it and you will be immortal
very far
One way: this way works for what ever size you choose. Example: you have a 12' long wall and you want beadboard 4' up from the floor the full length of the wall, use a chalk-line to snap a line 12'L & 4' up from floor, now you have the area laid out you need a good miter saw (hand or power) to cut your first piece, a lot of beadboard or wainscoting is 3-1/4" wide, Square the end first by cutting a thin piece off, now cut at a 45 degree angle, your saw should start at the very corner of your board, when cut you should have a small piece 3-1/4" wide, 3-1/4" tall with a 45 degree angle, that is the 1st piece to go into the corner. (Important) The angle of your first piece is the length of the short side of your next piece, because they will mate together, make sure you have the tongue & groove lined up correctly, male to female etc., HINT..... try it with paper first until you get the idea. (its very satisfying to do it yourself, an when your done you will say, Gee that wasn't so hard) Good-Luck!
Go to the High School and click on the door on the back wall.
If your dividing the wall the lighter paint should go on top