0
Hello, I recently replaced the fog bulbs on a 2000 ES300. I believe it should be the same procedure. I found it necessary to remove the Fog housing to replace the bulbs. First you'll need to get under the car. It isn't necessary to jack it up but you might find it easier with more clearance. Underneath the car, under where the Fog light is you'll see 2 screws on either side of the fog light. They are holding the plastic under body to the bumper. The screws will look like nuts with Philips head indentations in the middle. Remove these screws. After doing so pull down the plastic under body to obtain access to the back of the fog light. There is a nut on the inner side of the fog light that attaches it to the bumper (the side away from the outer side of the bumper) remove this nut and the fog light should be pretty loose. Now on the side that's closest to the edge of the bumper there is a plastic squeeze type retainer/clip at the top outer side of the fog light housing (still under the car inside of the bumper area). Gently squeeze this as you gently push the fog light out through the front of the bumper. Once you have it out unplug the harness from the back of the fog light housing. Now you can twist open the fog light to gain access to the bulb and replace it. Repeat the same steps for the other side. I hope this is adequate information to get you through the process painlessly. Good luck.
Thanks for the help. Everything went smoothly and this takes about 20 minutes to change the bulb. It would have been nice of Lexus to just place a screw on the outside.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace 1994 Lexus es300 brake light bulb?
you dont you get a new car
How do you replace a bulb located in the rear of a 1993 Lexus ES300?
Along the rear of the inside of the trunk there are four small bolts which need to be removed. Once removed, you will be able to push out the outer plastic cover holdind the light bulbs and wiring. From there, you can easily remove and replace the bulbs.
How do your replace tag light bulbs on a 1994 Lexus es 300?
no you do not
You replace all the tail light blubs on your 94 Lexus es300 and when you step on the brake the dash light come on?
incorrect resistance of light bulbs installed. causes electrical feed back. replace all bulbs with factory replacement Also check that the tail light ground is ok. If the tail light bulbs aren;t grounded, it causes a backfeed of power to the dash lights and causes them to turn on.
Shut off abs light on Lexus es300?
shut off abs light on 1998 es300
How do you replace 1997 LEXUS LS-400 parking light bulbs?
To replace the parking light bulbs, remove the screw on top of the headlight and pop out the clearance light. The parking light bulb will be accessible after this removal.
How do you replace rear deck brake light bulb on 1992 Lexus es300?
If you grab the light and pull it straight twards yourself it will come off. The bulb is in there
Will a 1999 Lexus ES300 tail light fit a 1992 Lexus ES300?
No there have been three body changes between those two years.
How do you replace the light bulbs in a 1991 Lexus LS 400?
email me and I will send you a pdf on how to change the body tailight bulbs. vbdenny
Dashboard lights on Lexus ES300?
There are quite a number of dashboard lights on Lexus ES300. The common ones include handbrake light, check engine, temperature, check oil, battery light and so many others.
How do you change the brake lights on a 1998 Lexus ES300?
To change brake light bulbs on a 1998 Lexus ES300, open the trunk lid. Locate the plastic rivet on the side of the trunk liner. Turn the rivet while pushing in with a screwdriver. Remove the rivet and the trunk liner can be pulled away to access the bulb. Push in and turn the bulb to remove. Insert the new bulb the same way. Replace the rivet in the trunk liner.
Window washer light on a 99 Lexus es300?
put more window washer fluid in....
