0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How heavy gear case oil goes secondary gearbox of a Suzuki 1200 madura?
First the fill hole has a hex head socket screw in the top of the trans. second you have to pull the cover plate over the gear box (4-8mm bolts) once that is removed there is a metal plate on the end of the trans. with 5 8mm bolts holding it on. In the center there is a 8mm screw in the center of that plate remove that. Fill the trans. from the top hole until oil comes out of the hole you removed the 8mm screw from. replace the 8mm screw then the hex head socket screw in the top, as well as the cover plate. CAUTION: PREFORM THIS WITH THE BIKE ON THE CENTER STAND.
What is the hole for in the stock of an mauser 8mm?
Buttstock hole is for bolt disassembly
What are the correct steps to use a chassis punch?
First drill the pilot hole normally an 8mm put some oil on the die and mandrill, split the die and mandrill and insert the bolt with the die in the pilot hole insert the mandrill on the opposite side and screw the bolt until the hole is finished
Will the hole of a flesh tunnel grow close?
it depends how large u stretch the ear lobe 'they' say after 8mm youre hole will never fully close, but go back down to a normal percing size.
How large is an 8mm tumor?
About the size of a marble!
How do you get the front rotors off of a 2002 suzuki grand vitara?
After you have removed the calipers and brake pad bridge you need to use 2 8mm x 125 pitch bolts they need to be about 1 inch long screw them in to the holes that are provided screw them until they pop off
How do you drain oil from 2007 cts?
shoot a hole in the talk with a 8mm assult rifle then weld the hole back toghter
How large is 8mm?
8 mm = 0.8 centimetres.
What size screw do you use to mount a samsung led tv 40 inch 6300 series?
A M8x19 screw (metric 8mm thread x 19mm length) is used to secure the 6300 series TV to a VESA wall mount. You will need 4 to mount it.
How do you check transmission fluid level for 2005 suzuki forenza?
Car has to be level on Jacks, and you will need a 8mm square drive to remove the plug. Where the right side axle goes out to the wheel from the transmission you will see a plug that the 8mm square drive will fit. Turn out the plug and fluid should just run out if its full. If none come out put your pinkie finger in the hole and you should get some fluid on your finger, if there is none you need to add fluid through that hole. You will need a suction gun to push fluid into the transmission.
You tried to replace the fan blower in your 2001 Dodge Grand Caravan It seems there is a screw in the back that neither you nor your mechanic was able to remove to enable him to get to the fan blower?
For that screw, you need to use a 5/16 (or 8mm) swivel 1/4 inch socket on a 6 inch extension and ratchet. You also need a mirror and flashlight to get the socket on the screw...the rest is patience and determination. For some of the vans from that era that screw is installed from the top. The dash has to be removed to change it.
Need example of 8mm?
Thickness (width) of a pencil.
