answersLogoWhite

0


Best Answer

About 1 hour at the most.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How long does it take to change a starter motor on a jeep?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How long to change starter motor on vauxhall vivaro?

35mins


Will a 2.5ltr jeep motor mount into a suzuki samurai?

yes, as long as you change all components to that for a Jeep


How long does it take change crank sensoron 2002 olds intrigue 3.5 engine?

one hour or less remove the starter on the lower front of the motor and the sensor is right above the starter held in with one bolt


How do you locate and change the starter motor on a 1990 Pontiac Le mans Sedan?

The starter motor is about 8" long and cylindrical. It is found on the rear side of the engine, down low. Make sure that you disconnect the negative battery terminal first, because the power cable going to the starter is live. A couple of bolts hold it on to the bell-housing for the transmission.


Is a car starter affected by cold weather?

Cold weather can affect a car starter if you overwork by holding it in the on position too long and repeatedly. The starter motor can wear out.


How go you change a starter on a 1995 jaguar xj6?

I just did this job The hardest part is getting the top bolt out to remove the starter. The only way I could do it was to remove the windshield wiper motor. Removal of the motor is hard but not impossible. That gave me enough room to get a long box-end wrench on the head of the bolt and turn it out. The rest of the job is pretty straitforward


How to change the starter motor on a 95 yj?

Label wires and take them off from the soloniod, there should be two long bolts that bolt the whole assembly to the engine block , undo the bolts and starter and solonoid come out of bellhousing and off engine block. to install repeat steps backwords


How long does it take to change a starter in a 2000 Chevy impala?

32.8 sec.


Will a c6 transmission connect to a 352 fe engine?

Yes it will as long as it's a FE C6. Also, if you do install it make sure of the starter you have. If you have the long neck style starter you will need to replace the flywheel and starter to have it fit. You can use the one from a 66 and up 390 motor.


How many bolts holds your transmission to your motor 91 acura integra?

i think 6 with the long 14" starter bolt


How do you change the spark plugs on a 2003 Jeep Rubicon?

remove the bolts holding the coil pack to the engine.(the long black plastic thing on the side of the engine about 1.5" x 2" x the length of the motor) This will expose the spark plugs.


What is the effect of long armoured cable used for star delta starter for 3 phase ac motor?

voltage drop is be a problem.