It takes an hour if you do the following:
Make sure you have:
3/8 in breaker bar
15mm socket
29mm hub socket
3/8 in drive elbow
3/8 in short drive extender
3/8 in socket ratchet
jack & lug wrench
Compressor and impact wrench (with adapter to connect to 3/8 in drive socket)
3 jaw bearing puller
See eBay instructions on how to do the work but add these gems:
A. Use the three jaw puller to push the spindle back toward the center of the vehicle so that there is clearance to get the impact wrench with the 3/8 in elbow and extender in there on the hub bolts.
B. The three jaw puller and a hammer can take the place of the slide hammer they recommend for the final hub removal
Without the impact wrench the three hub bolts take forever to remove (I broke two and wore out my arm joints). Using the puller to push the spindle in give you more clearance to get that socket on those bolts. The air wrench make quick work of it. Its the difference between getting the job done in 3 hours vs. 40 minutes.
It will cost approximately $150 to change the front wheel bearing on your 2000 Ford Explorer. The wheel bearing will cost approximately $30 and require two hours of labor to install.
how to replace front wheel bearing on 1996 Hyundai elentra
To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.
Take wheel off, put bearing in
the cost for driverside wheel bearing on my 2002 ford,explorer,xls-4door,4x4 was $130.00 at the advanced auto store locally. if your explorer is a sport explorer i have a front wheeling bearing that i will sell you for 75.00 still in the box. i missordered. other wise, specifie the model. good luck!
Is the wheel bearing on the front or the rear ????.. There is a big difference ...
You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.
tourqe on 2001 front wheel bearings
The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.
you can replace it by taking it to the shop and they will do it for you.
How do you replace front wheel bearing on a ford focus
Get a manual for this vehicle.