You need to wait for 30 minutes before you switch it on. It's enough time to let the refrigerant liquid settle down.
Generally you should wait for around 24 hours.
best to let it sit for 12 - 24 hrs before plugging it back in, esp if it was laid on its side
You should be able to plug it right in, unless there is something wrong with it.
You could. But you should not because of the freon in the lines. If the fridge was transported upright is should be ok but if it was lying down (not good) you should stand it up for a while before you turn it on.
Newer vehicle with electronic ignition probably 100,000 miles
It should charge as long as it is supported. If not supported then nothing will happen
As long as they are both the 4l60e, which they should be it should just be a plug and play.
to stop them from moving
12 to 24 hrs after she should start birthing
below 20 ferinheight for a couple hours
Remove the spark plug wires from the spark plug. Be sure to leave the other end attached to the distributer cap. Then remove that spark plug from the cylinder with a spark plug wrench and re-insert the plug into the spark plug wire boot that you previously removed. Have someone turn the inition key as if starting the engine. Stay clear of moving parts etc. while observing the spark plug end. You should see a spark.
unplug it and plug it back in to the computer
PLUG GAP SHOULD BE 0.6-0.7MM.BEST PLUG IS AN NGK D9EA. PLUG GAP SHOULD BE 0.6-0.7MM.BEST PLUG IS AN NGK D9EA.
Get the wire and plug it all in plug. The plug should be looking like a USB and should go in the USB.