my balls
The paint was not fully cured when you used the shower. Now it will not dry until you stop using the shower for an extended time. Your option is to prime with a water based primer, allow to dry fully, coat with a eggshell or better coat, allow to dry fully, then recoat. Then allow to dry fully prior to using the shower.
No, the prime coat can go on anytime.
Mixing clearcoat with paint, will ruin the paint.For enamel paints, make sure you use an enamel clearcoat. You should allow the paint to fully cure (at least a week) before attempting to apply the clearcoat. Never use a lacquer based clearcoat on an enamel based paint. It will ruin it.For lacquer based paint, you should only use a lacquer based clearcoat. The paint should be dry, but does not have to be fully cured, since the lacquer will wet the coat of paint below it anyway.
The major importance of prime coat on base course should be to produce an appropriate surface for a stronger bond between the asphalt binder course and the base course. Apart from this, the prime coat also discourages the intrusion of surface moisture into the underlying layers.
There is a substantial amount of misinformation concerning the function and proper use of prime. Prime is not glue-causing the base to adhere to the pavement is not its purpose. Prime's purpose is to protect the base from rain and light traffic, when the paving will be delayed.A prime coat is an application of an asphalt cutback or emulsified asphalt to a prepared base. The base can be either a sub grade or a base rock. Prime functions as a protector from rain for both types of bases. A primecoat should not be confused with a tack coat. Tack is an a adhesive for gluing two asphalt layers together.
You should generally wait a full 24 hours before adding a second coat of clear to a vehicle. This allows it to fully dry and cure for the best results.
.1 to .25
No. The spar varnish acts as the sealer. Apply a thin coat and allow it to dry. Apply a second coat and allow it to dry. These two coats should have sealed the pores of the wood. Apply the third coat slightly thicker, so you get a nice even "wet look" to the wood.
The endospore coat is composed of enzymes which are used in germination. The coat does not allow large toxic molecules to penetrate it.
enrobed? to coat or fully cover an item with a dissimilar substance
Exactly like a top coat of paint: with a brush, a roller or a sprayer, depending on the surface being coated.
In exposed and semi-exposed interior environments, the applied intumescent paint should be coated with a compatible finish coat, in order to give the desired colour and seal the coating. The topcoat system must be suitable for the environment in which it is to be used and should be a good quality, long oil alkyd, silicone, acrylic latex or polyurethane type. All topcoats should be applied in accordance with the topcoat manufacturer's recommendations. Ensure that the coating is thoroughly dry before application of top coat. Typically, allow a minimum of 7 days for the intumescent coating to fully cure before application of any top coat system. The intumescent paint manufacturer should be contacted to ensure compatibility of the top coat system.