0
What else can I help you with?
Will the electronic distributor from a 1977 dodge with 225 six cylynder fit and work ok in a 1960 225 six?
yes it should work as long as they are both 225 slant 6's.
How long did Victorian maids work?
About 12-16 hours approximately
How long should you work on reviving newborn pup?
not long
Will a distributor off 1988 5.0l work in 1989 irocz 350 tpi?
It is the samething. same distributor.
How long before you can return to work after adult tonsillectomy?
It takes approximately three weeks to return to work after an adult tonsillectomy.
How do you work out 5 divided by 18?
0.2778
Yes. It should work as long as your Sony TV has the appropriate inputs.?
Yes. It should work as long as your Sony TV has the appropriate inputs.
Should you work in food shop with hsv1?
Approximately 80% of people have HSV-1. It is OK to work in a food shop.
Replacing distributor on 98 vortech 305 when the old position was not marked. Can you set the engine at TDC and line the distributor rotor up with 1 cylinder postion?
That should work, but be remember you may be 180o off, so you mave have to adjust.
Can a distributor from a 1992 Chevy c-1500 350 engine electronic advance work on a 1969 396 Chevy?
yes as long as you swap electric parts
Can a distributor be one notch off and still work as long as the number one wire goes where the rotor is pointing?
If you can find the mark with a timing light, yes.
What is a Pickup coil assembly?
Without this, your distributor won't work. Without your distributor... :( Go to your distributor. On the outside of it you should see a plug with harness (?) feeding into the distributor. This is the beginning of your pickup coil "assembly". Take off your distributor cap. You'll see that "harness"/assembly feeds into the very top of your distributor, held by a "molded" grommet (on mine), then, it "coils" around the top and you'll see that it feeds (or plugs into) into some part of the distributor (again, you can only see this when your distributor cap is off). I'm basing all of this on my 84 CJ7. I have no clue if all distributors are the same. Good luck.
