Want this question answered?
The lamp uses 240 x 4.9 VA, that is 1176 VA, so a 15 kVA transformer, which is 15,000 VA, could feed 12 lamps.
This depends on what voltage the range is rated for and if it is single phase or three phase. At 220 volts single phase it is about 60 amps, 240 v single phase , 53 amps and at 480 v three phase about 15 amps.
A 1-HP motor is reckoned to draw 7 amps at 240 v single-phase. The same power of motor would draw 3.5 amps at 480 v single-phase, but a 480 v supply could most likely be a three-phase suppy, and the current in that case would be reckoned as 2 amps.
10 Amps. Amps=Watts/Volts
45000 / 208 /sqrt(3) = 125A per phase this is probably called a boiler unless it has a 2000Gallon tank
No, your amp draw will not be reduced. It will actually be slightly higher because the transformer will not be 100% efficient. Contact TEMCo Phase Converters at (800) 613-2290 if you have any more questions.
draw a robot draw a robot
The lamp uses 240 x 4.9 VA, that is 1176 VA, so a 15 kVA transformer, which is 15,000 VA, could feed 12 lamps.
In order to draw the phase diagram for transformer operating at load with lagging PF and leading PF, you will need to know the equation for the transformer being load free. This constant will help you with the load bearing equation of Np/Ns=Vp/Vs=Is/Ip.
You can use multiple appliances as long as long as you don't draw more current than the transformer can supply.
This depends on what voltage the range is rated for and if it is single phase or three phase. At 220 volts single phase it is about 60 amps, 240 v single phase , 53 amps and at 480 v three phase about 15 amps.
To answer this question, the purpose of what the push buttons and lights will be required to do in the circuit, has to be stated.
16.81 amp.
5amps
A single phase 10 HP motor will draw aproximately 50 amps. A three phase 10 HP motor will draw aproximately 28 amps.
Some 3-phase machinery can be adapted for use in a 2-phase system using a phase-shifting capacitor (See the related link for a (German) Wikipedia article about the Steinmetz circuit for details).However, a welding transformer is likely to draw too much power and thus be unsuitable for this trick. It will probably be cheaper to install a 3-phase connector in the residential home (many houses have 3 phases installed at the meter board), or to load a welding transformer for use with a single-phase residential system (if this is for a single occasion).
You still need the same horsepower. The advantage of the three-phase motor is that it will draw lower current.