The electrical code states that a 30 HP induction motor at 460 volts three phase will draw 40 amps.
<<>>
I = 33.34 AMPS IF EFF.= 95% AND P.F.= 85%
37.5
The the supply stays within +/- 5% of what the motor is rated for, you can do this.
3 phase reverse relay can be utilized to control 480V motor 60HZ for controlling their speedspeed.
One way would be to hook it up to a supply (by itself, with no load) and measure the speed with a contact tachometer. If your supply is 60Hz, and the motor speed corresponded to one of the standard motor speeds, it would be a pretty safe bet you had a 60Hz motor. If the speed was about 20% faster than a standard speed, the motor is probably a 50Hz motor. Or 20% slower if you were running a 60Hz motor on 50Hz For instance, a 1750 RPM 50Hz motor would spin at about 2100 RPM if you ran it on 60Hz.
It is an extremely expensive way of utilizing the deep fat fryer. You should look into changing the heating coils in the fryer to utilize the new voltage. That said it can be done.
yes can run but motor only delivers 90%rated power because v/f less by 10%
The the supply stays within +/- 5% of what the motor is rated for, you can do this.
3 phase reverse relay can be utilized to control 480V motor 60HZ for controlling their speedspeed.
The motor will run, probably at nearly the same speed, but it cannot supply the same mechanical load. If it can be run on a lighter load, proportional to the voltage, it should be OK.
This should not be a problem but check with the manufacturer of the laundry equipment to be certain.
One way would be to hook it up to a supply (by itself, with no load) and measure the speed with a contact tachometer. If your supply is 60Hz, and the motor speed corresponded to one of the standard motor speeds, it would be a pretty safe bet you had a 60Hz motor. If the speed was about 20% faster than a standard speed, the motor is probably a 50Hz motor. Or 20% slower if you were running a 60Hz motor on 50Hz For instance, a 1750 RPM 50Hz motor would spin at about 2100 RPM if you ran it on 60Hz.
It is an extremely expensive way of utilizing the deep fat fryer. You should look into changing the heating coils in the fryer to utilize the new voltage. That said it can be done.
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
Yes, most VFDs can run faster than the input power frequency so you can run a motor to 60Hz with a 50Hz power source. Just be aware that as speed increases, so will the current. Also be aware that a motor is rated to run a specific rpm and running faster may cause motor bearing failure after a short time.
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
It will not work at all.
No! Normally not, the recistance in the windings is to hig on 60Hz and the pump motor has not power enough to work propelly. This happened to myself when I connected my Whirpool AWE 7519 to 230V 60Hz. Europian model for 50Hz.