0
How many bolts bolt the engine to the transmission on a 1997 Mercury Sable?
Wiki User
∙ 12y ago
Bolts by the starter(2 on starter) and 5 or 6 around the transmission housing and 2 up by the front of the motor near the axle for the passenger side front wheel where you can't see them.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How many bolts does a 98 Mercury Sable transmission pan have?
17 with 3.0 19 with dohc 3.o
How many bolts in 2000 Mercury Sable starter?
The 2000 Mercury Sable starter will have three retaining bolts. There will be two cable retaining nuts on the front of the starter.
How is the fly wheel attached to the starter on a 2001 mercury sable?
It`s not attached to the flywheel. It bolts to the engine block through the bellhousing.
What is the rocker torque specs for 3.0 12v mercury sable?
torque specs 2000 mercury sable 3.0 12V rod bolts
Where is the transmission drain plug on a Mercury Sable?
What year + engine (3.0L SOHC, 3.0L DOHC or ??)? ... MOST American built cars/ trucks do NOT have a 'drain' plug! -In this case, you need to remove ALL the bolts holding the pan on (it's a messy job, IF this is your first time)
How many bolts are there to take out on an 1993 Mercury Sable starter?
three bolts, make sure the battery is disconnected first!gmjim
How many bolts hold the transmission to the engine on a 1995 K1500 Z71?
6 bolts hold the transmission to the back of the engine.
Where is bell housing 1994 chrysler New Yorker?
It is the part of the transmission case that bolts to the engine.It is the part of the transmission case that bolts to the engine.
Where is the catalytic converter located on a 1997 Mercury Sable?
it is under the car just behind the engine in the exhust pipe but if it needs to be replaced take it to a muffle shop its not a doit your self unless it bolts in but most have to be welded
Where do you hook engine stand on back left of 1996 Chevy Blazer engine?
The engine stand bolts up to where the transmission bolts to the back of the engine.
Where is the bell housing on 1999 dodge ram truck 5.2L?
The bell housing is the front of the transmission, the end that bolts to the engine.The bell housing is the front of the transmission, the end that bolts to the engine.
How do you replace Mercury Sable front struts?
The front struts on a Mercury Sable are replaced by jacking up the vehicle, removing the wheels, and supporting the vehicle on jack stands. The retaining bolts can then be removed, the struts taken out, and new struts put in place.
