6 bolts hold the transmission to the back of the engine.
It requires a electronic 700r
The bell housing is the front part of the transmission case. It is what houses the torque converter and bolts to the engine.
the starter is on transmission's side above the right drive axle It bolts on close to where the transmission bolts to the engine. It's held on by a few bolts and is about the size of a 12 oz pop can. You should be able to see it without getting under the car.
Drain the oil from your 1995 Chevrolet oil pan. Remove the oil pan retaining bolts. The oil pan will come off.
it is bolted to the distributor just under the distributor cap.
I have a 1994 5.7 k1500, and my book says for V8 5.7 1988-1995 is TDC. (top dead center)
Do you need the engine to be running when adding transmission fluid to a 1995 ford aerostar
Inside the transmission - remove transmission oil pan - should be secured by 2 short bolts
The gross weight rating capacity on your 1995 K1500 suburban is stated at 3000 pounds. The towing capacity of your 1995 K1500 is stated at 7500 pounds.
20qt w/ AC 17.5qt w/o AC
The starter is located on the back side of the engine. The two mount bolts go through the transmission into the starter. There is a bracket on the back side of the engine which I found easier to remove first and then undo the starter.
the best answer i have for this is. buy a haynes manual. there are many things i can tell you like take the wheels, cv-shafts, block the engine, disconnect transmission lines/shifter & kickdown, take off torque converter cover and bolts and remove transmission bolts. however the manual has pictures and allows you to get a better idea of what you are doing.