0
How many bolts hold the starter motor on a 1.2 fiat bravo 1999?
Wiki User
∙ 14y ago
3 bolts 1 top 2 bottom feel around you'll find them
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the starter motor on a 1999 Chevrolet suburban?
below the engine, passenger side, at the rear. 1 small trigger wire, 1 heavy battery cable, 2 starter mounting bolts.
How do you get the starter off a 1999 outback sport?
undo the bolts
1999 Chrysler Town and Country starter installation?
To install the starter, hold the starter motor spacer in position, install the starter motor-to-transaxle bell housing bolts, tighten it, and engage the solenoid wiring connector onto the terminal. Then, connect the B+ wire, tighten the retaining nut, lower the vehicle, connect the negative battery cable and verify starter motor operation. ÊÊ
How do you remove the starter from a 1999 Audi a6?
How do i remove an Audi A6 Starter motor
How do you replace starter motor on 1999 jetta?
disconnected the batteris - disconnet the wiring on starter motor,make not of the cables remove the two bolts securing the start to the car, installation is reverse Disconnect and REMOVE the battery. This allows you to get to the wires on the starter much easier. Then remove starter. Be sure to get the small bearing out of the housing and replace it. A new one should come with the starter, but if it does not, get one and put it in.
How do you change the starter on a 1999 Chevy Prizm?
Remove the positive cable from your 1999 Chevy battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
1999 sentra starter?
The 1999 Sentra starter is located right beside the transmission bell housing. That is the housing where the transmission bolts up to the engine.
Where is the starter located on a 1999 Chevy s-10?
On the passenger side of the engine where the transmission bolts to the engine block. Or you can disconnect the positive battery cable and trace it down to the starter. You can disconnect the large cable and the small wire from the ignition switch, the motor is held on by 2 bolts going up from the bottom, there may be shims between the motor and engine block.
How do you change a starter on a Nissan Maxima 1999?
* Disconnect the negative battery cable * Remove the air intake duct and the air cleaner housing assembly from the engine compartment * Disconnect the battery cable and the solenoid terminal connection from the starter solenoid * Remove the starter motor mounting bolts and detach the starter from the engine
How do you take a starter out of Nissan primera?
how do you take a starter motor off of a 1999 nissan primera auto
How do you replace the starter in a 1999 Nissan Maxima 3.0?
* Disconnect the negative battery cable * Remove the air intake duct and the air cleaner housing assembly from the engine compartment * Disconnect the battery cable and the solenoid terminal connection from the starter solenoid * Remove the starter motor mounting bolts and detach the starter from the engine
How do you replace the starter on a 1999 Buick Century?
first disconnect the battery. remove the bolts that support the starter. you may have to wiggle the starter out after you disconnect all of the wires going to the starter
