Want this question answered?
In 1985 my FANS and I would exchange Belts one for one at our favorite bar. I we hade to many then definitly ended up Buicking in the old Riviera what order to replace them
2
Just one
Fan belts are used to turn the fan in an automobile to cool off your radiator, or in a computer to pull cool air into the motor to keep it from overheating.
how do you replace the belts on a l-1011 fan jet
you should have three belts total. Going from the fan towards the distributer the first belt should be the power steering, then the actual fan belt, then the third belt is the alternator / a/c belt, i hope this is helpful for you! So for the answer to your question, there is one fan belt, the second belt in from the fan!
First of all, they are the same as the fan belts on any other car. The fan belt(s) are the serpentine drive belt(s) that turn your fan and other accessories (like alternator, compressor, power steering) They are often referred to as serpentine belts, drive belts, and accessory drive belts. The are located on the outside of your engine, driven by the main pulley (crankshaft pulley). R. Mesyef
Put the new fan belts around the fan pulleys. Slide the top tensioner pulley upward. Tighten down the tensioner pulley when you have achieved the proper fan belt tension.
Dodge Dynastys dont have Fan Belts... Their fans run on an electric motor.
take the fan out and behind the fan there should be a chip.
on what type of vehicle
Bando USA online offers 'belts' for ones automobile. These belts include, but are not limited to, 'serpentine, V-belts, timing belts, rubber belts and fan belts. They also carry belts for transmissions.