Want this question answered?
Flywheel must be torqued to 105 ft/lbs. Clutch and pressure plate torqued to 22 ft/lbs.
remove transmission, remove torque converter (auto), or clutch and pressure plate (manual) remove flywheel flywheel and pressure plate must be Torqued to factory specs
i have replaced my clutch to 10.5 diemter ,can i re use the morso flywheel/clutch bolts
what are the torque specs for clutch and fly wheel model 5700
65ft lbs
Flywheel Torque 61-69 Foot pounds
257 FT Pounds of torque.
The Clutch is sandwiched between the pressure plate and the flywheel. The flywheel spins with the crankshaft and the pressure plate presses the clutch disk to the flywheel. The flywheel transmits torque to the transaxle input shaft through splines along the inner hole in the clutch. The clutch is between the engine and the transaxle Dean Schrickel, P.E.
The Polaris Sportsmen 800 has 120 pounds of engine torque. The torque is measured at the flywheel. There is only 100 pounds of torque at the ground.
you have to drop the transmission and the cluch's pressure plate will be bolted to the engine's flywheel. you unbolt about 6 blots and take the pressure plate and the clutch disk out and make sure you get the pilot bushing and have the flywheel turned unless you are replacing the flywheel too. then torque the bolts to reqs and clutches are usually around 15 to 24 foot pounds on fords
For your 1992 Nissan/Datsun 300ZX: Flywheel Torque 61-69 Foot pounds (Final torque)
89ft/pounds