0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
On a Hyndai Santa Fe is there a fuse for trail lights for a camper?
Many vehicle manufactures fuse the trailer connection separately from the vehicle's systems. This is to prevent the vehicle from losing it's lights due to a problem with the trailer's lighting. Look in the owner's manual or look online for a fuse placement diagram. The fuse may be marked "trailer."
Where are trailer lights sold?
Trailer lights are sold at many stores nationwide. You can find trailer lights at home improvement stores. You can also find trailer lights at automobile repair stores.
Trailer Lights?
form_title= Trailer Lights form_header= Install trailer lights with help from pros. Do you have a commercial trailer?*= () Yes () No What color lights do you want to install?*= _ [50] How many lights do you want to install?*= {1, 2, 3, 4, 5, More than 5}
What could be causing the fuse for the dash lights to keep blowing on a 1988 Cherokee Laredo?
Short in the wiring. If you have a trailer wiring harness check it for frayed wires. The tailight circuit and the dash lights share a circuit on many vehicles. I hope this helps you. Mark
Where do i find a restroom trailer?
There are several websites that sell restroom trailers. Many trailer sales locations will also offer restroom trailers.
How many red an white lights are on the back of an 18 wheeler?
There must be at least seven red lights on the back of a trailer.
2002 Dodge Durango Pulled a boat from lake now I don't have tailights or dashboard lights. 4-ways turn signals and brakelights are all ok Checked fuses all seemok is there anything else?
{Owner's Manual} Find the page that details the fuse layout and replace the dash light fuse. You cannot always determine if a fuse is blown by visual inspection. Either check it with a volt-ohm meter (set on ohms or continuity) or replace the fuse with a new, "known good" fuse and test. (borrow one of the same amp rating from the fuse box and test with it, remembering where you got it so you can put it back after the test) You may have two fuses blown depending on how many fused circuits were submerged when the boat was loaded on the trailer. (For safety reasons some manufacturers deliberately fuse the dash lights with the tail lights so the driver will know when his tail lights aren't working-This is accomplished by making the tail and dash lights one big series circuit or loop and if any part of it breaks down and fails to conduct current none of the circuit will operate. So, it could be a bad fuse or a single burned out tail light lamp as the culprit. Also, if you have a plug for the trailer lights you may want to unhook the trailer lights, make sure the plug is dry and test without the trailer lights in the circuit. The correct method is to isolate the problem(s) one at a time. Start with the trailer unplugged and test, then replace the dash fuse, then locate the tail lights fuse. If the fuse doesn't fix it then you may have to replace one or more of the tail light lamps. If they get wet when burning they usually blow immediately, which is why heavy driving rains that penetrate around the lenses will sometimes blow auto lamps. (cold water on hot glass=broken lamp, or, dead short across a submerged lamp socket may blow the lamp without blowing fuse)
How many fuses control the turn signals and brake lights?
It depends on the vehicle but in general you would have one fuse for the signals and one fuse for the brake lights.
Where can you buy neon green lights?
One can purchase neon green lights at many locations. One can find these type of lights at retail locations such as: Canadian Tire, Walmart, etc. One can also find neon lights at online retailers such as Amazon, Ebay, etc.
Where can someone find trailer ramps?
There are many stores that sell trailer ramps. Two well known stores that sell them are Lowe's and Sears. Both Lowe's and Sears have many locations across the United States.
What could cause the left turn signals to remain on in a 1999 dodge caravan even when the fuse is pulled Both front and rear left stay lit I pulled all fuses but lights remain on?
There is no possible way the light could remain lit if the fuse of that particular circuit was pulled. A fuse acts as a safety switch, once it is blown (or pulled) current cannot flow in that circuit. I disagree with the previous poster. There are MANY possible ways for the bulb to remain lit with the fuse pulled. The first one that comes to mind is damaged wiring. There could be power from a different circuit feeding the bulb. There may be a dead-short near-by, sending power to ground; lighting the bulb "backwards". But since it's a Dodge, I'd bet that the wiring to the trailer tow plug (7-way) has corroded apart and the circuit is being back-fed by the "trailer battery charge" wire. Quick way to check is to pull fuses for the trailer wiring (see owner's manual for locations). If the lights go out, cut off the trailer plug and install a new one (you may have to remove a lot of corroded wire; be prepared to splice as needed using heat-shrink connectors).
Which fuse is for brake lights?
Each car is different, have a look at your owners manual and it should give you a legend for the fuse panel, many also have it written on the inside of the fuse panel cover.
