0
How many gear wheels on the main shaft of the four speed gear box?
Wiki User
∙ 13y ago
4gears
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is a vehicle speed sensor drive gear?
Its the gear that connects the speed sensor shaft to the transmission
How does a manual transmission in a car work?
There are two shafts which run through the gearbox, the input shaft and the output shaft, and the two are connect by pairs of gearwheels, one for every 'gear' of the car. They are paired together: Gear 1 will have a small wheel on the input shaft and a large wheel on the output shaft, meaning less speed and more turning force. Gear 5 will have a large wheel on the input shaft and a small wheel on the output shaft, to ensure a high speed. Moving the gear stick to select a gear pulls a 'synchromesh' into place. This locks the input shaft a gear on the input shaft, allowing the movement to be transferred to the output shaft via that particular 'gear'. In the Neutral setting, the synchromeshes are all disengaged. In Reverse gear, there are three wheels involved in the transmission, instead of two.
How a transmission works?
input shaft is linked to engine, output shaft is linked to wheels. clutch plates (friction based) allow it to apply different gear ratio's, which allows you to build speed quicker
How does an engine works and the function of a gearbox?
An engine is a device that converts chemical energy in the fuel to mechanical and heat energy. This mechanical energy is used to drive a crank shaft which is used to power the wheels of an automobile. The crack shaft is connected to a gear-box which changes the speed and torque of the drive shaft. A lower gear (low speed and high torque) is used for acceleration from halt and a higher gear (high speed and low torque) is used for cruising.
What is an overdrive gear?
A gear which causes the transmission output shaft to rotate at a higher speed than the transmission input shaft.
These are toothed wheels which can change speed and direction?
GEAR
Will a larger gear on the driving shaft increase the speed of rotation of the driven shaft?
no it will slow it down
What is a gear shaft on a bmx bike?
It'd be a fairly strange BMX if it has a gear shaft. Most "real" BMXes are single speed, their driveline consists of cranks, a bottom bracket and the rear hub. No gear shaft there.
What is the funcion of a ring gear?
It is to transfer the power between the driveshaft and the wheels. The drive shaft drives the pinion, the pinion drives the ring gear, the ring gear drives the axle(s) and the axle(s) drives the wheels.
When a car is on its first gear the rear wheels turn very slowly?
First gear is the lowest gear ratio in the transmission among the forward gears, where the input shaft will turn multiple times for each turn of the output shaft.
Is there anyway it increase the power out put of a motor?
The power output of a motor can be changed by the use of gears. Gears can be used to increase torque by reducing the speed of the output shaft by placing a large gear on the output shaft, coupled to a smaller gear. Conversely, by using a small gear on the output shaft, coupled to a larger gear, the speed can be increased with a reduction in torque.
How does the steering wheel work?
turns a shaft connect to steering gear box, which then turns wheels through different ways
