It varies. For instance, my 1994 4X4 5 speed Dakota had 12 grease fittings from manufacturer, but my 2002 4X4 5 speed has none (all factory installed components are sealed). Plus retrofitted parts may or may not change that number.
Basically, you have to get underneath and look. The rear end should have none, they'll just be front end and drivetrain components. Here's where to expect to find them, if equipped:
If they're not there, don't worry too much about it, it just means it's a sealed component. Just check for proper function and signs of wear, and replace as necessary, you can't lube them.
No.No.
There are no grease fittings on the wheel of any car. The wheel bearings must be removed, cleaned, inspected, repacked, and replaced.
Use 10w30 in a 1995 Dodge Dakota.
were id the data link connector for a 1995 dodge dakota
Where can I get a free copy of a 1995 Dodge Dakota Sport Owners Manual
Yes, but you will have to use your 1995 intake.
I have a 1995 400cc Polaris scrambler and I count 15.
Unless you find some grease fittings there is no lubrication necessary as they are sealed units.
No, Dodge does not use inertia/reset switches.
There is no difference in a 1995 dodge dakota with a 3.9 v6 engine and a 2000 dodge dakota with a 3.9 v6 engine and you can exchange the newer engine with the older one.
Yes. A 3.9 v6 engine from a 1995 Dodge Dakota will fit into a 2000 Dodge Dakota with a 3.9 v6 engine. You will have to swap the intake and exhaust manifolds along with all sensors and fuel rail though.
No.