0
How many inches of block lift can be put on an 1988 Jeep Comanche without modifying brake lines or suspension etc?
Wiki User
∙ 16y ago
None. The Comanche uses a spring under axle setup and blocking the axle would lower the vehicle. However, if you can use a torch and weld, you can cut your spring mounts, do some grinding and relocate them to the topside of the axle housing, and turn it into a spring over axle setup, giving you about 4.5in. of lift in the rear.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How tall is a KTM 125 exc?
2006 KTM 125 EXC Seat height 36.4 inches Ground clearance 15.4 inches Front suspension travel 11.8 inches Rear suspension travel 13.2 inches
What type of bicycle has 8 inches of suspension travel and 8 speeds?
A Downhill Bike!
Why are the last 12 inches of the front brake lines made of rubber?
To allow for steering and suspension movement.
What is the measurements of a Jeep Comanche bed?
The long bed version has a bed 7.5 feet in length and 43 inches in width between the wheel wells.
What is a 4 inch suspension lift?
A 4-inch suspension lift refers to a modification made to a vehicle's suspension system to increase the distance between the ground and the chassis by 4 inches. This lift typically involves installing new suspension components such as new springs, shocks, and control arms to accommodate the increased height. It is commonly done on off-road vehicles to improve ground clearance and allow for larger tires.
What is inches into 28 ft?
336 inches - without using a calculator !
Can 24 rims fit on a 1997 Cadillac Deville?
they could fit but youwould have to modify the suspension a couple of inches of lift would be need . then they would fit . but it if you dont lift the suspension the tires will rub the wheel wells . !
How do you adjust the rear suspension on a 1973 VW Beetle if the passenger side is higher than the drivers side by three inches?
Sounds like you may have broken rear suspension parts. Sway bar or spring may be broken.
When installing a suspension lift kit on a vehicle that already has a body lift kit how should you determine what length of shocks to use?
The body lift does not matter, it just lifts the body. The only thing you need to worry about is the length the new suspension will add to the stock suspension. For example if you put on a 4" suspension lift then you will need to add about 5" - 7" inches in the shock to make sure you have enough up and down travel within the suspension lift, and that it does not "bottom out".
How many inches go into 15 centimeters without a decimal?
It is 5 inches.
What is the legal limit you can saw off a 20GA shotgun?
No shotgun can legally be shorter than 18.5 inches, without having prior approval from the Bureau of Alcohol, Tobacco, Firearms, and Explosives. Also, some states have rules about modifying weapons, so be ABSOLUTELY SURE to know your local laws before you shorten your gun.
How high is a honda crf 450?
The seat height is 37.5 inches, ground clearance is 13 incnes. Overall height of the bike is 49.4 inches. It is possible to lower the suspension of the bike and lower it but this carries extra cost.
