That depends on which vehicle. Some have more than one.
Knock sensor = CKP sensor on this vehicle.
That year vehicle has a carburetor and does not use a knock sensor.
Yes, you should always run your vehicle with its Knock sensor.
The knock sensor on that vehicle is located under the intake manifold. The intake manifold must be removed to gain access to the knock sensor.
if a knock gos bad can your car go off
You shouldn't have to - the knock sensor is supposed to adjust the timing automatically. If the vehicle is mistimed, you might need to replace the knock sensor.
LS does not have a knock sensor. GSR does have a knock sensor
The 2001 Chevrolet Suburban is equipped with one knock sensor. The knock sensor will be attached to the back of the engine.
The knock sensor detects spark knock or ping.
One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
2
Where is the knock sensor for a 99 pathfinder