It depends on the current rating of the armature winding, which will determine its input power. It's output power then depends on the motor's efficiency.
No. You need 12 volt AC to run a 12 volt AC motor, not 12 volt DC.
no
The voltage of 120 volts is more common that the lower voltage of 12 volts.
The Thunderbolt ignition is a 12 volt system.
To wire a 12-volt heater motor in place of a 2-wire 6-volt heater motor, first ensure that your power source can supply 12 volts. Connect the positive wire from the 12-volt heater motor to the positive terminal of the power supply, and connect the negative wire to the negative terminal. Make sure to use appropriate fuses or circuit breakers to protect the system from overcurrent. Lastly, confirm that the motor's specifications are compatible with your application to avoid damage.
expecto patronum! ~:)
....on an automobile it is a 12 volt DC motor. the electric cooling fan is driven from this type motor.....
Well, sugar, technically a 12 volt battery can run a 9 volt motor, but you might want to slow your roll there. The motor might run hotter and faster than it's supposed to, so it could burn out quicker than a candle in a hurricane. Just stick to using the right voltage for that motor, honey, and save yourself the trouble.
If you can get the battery to run the motor, write it up in a science journal. You'll be rich. Sure but what are you going to use to power the 12 volt motor? You will have to use another battery which you could just use to power the radio in the first place.
It depends on the battery's voltage. Such a battery's capacity is given in ampere-hours, not amperes. An 850 amp-hour 12 volt battery can theoretically operate a 12 volt motor for about 12 minutes but in practice it's probably, maybe a lot less, since the motor will probably stop as the battery nears its depletion.
A reversal of polarity in a 12-volt motor can occur if the wiring connections are switched or if a DPDT (double pole, double throw) switch is used to change the direction of current flow through the motor. It can also happen if a control circuit such as an H-bridge is used to control the motor direction.
Look on the motor case and the correct voltage should be printed there. Otherwise, see if it runs at the right speed on 6 volts.