0
What else can I help you with?
How do you change a starter on a 1993 Acura Integra?
To change a starter from a 1993 Acura Integra remove the mounting bolts that connect it to the transmission. Then unplug the solenoid from the wire harness. Install the new unit.
What do you do if you brake the head bolts?
on a acura integra type r if you brake the head bolts what do you do on a acura integra type r if you brake the head bolts what do you do
How many bolts holds your transmission to your motor 91 acura integra?
i think 6 with the long 14" starter bolt
Where are the starter mounting bolts on a 94 Toyota 4x4 pickup?
The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.
You lost the bolts for your starter?
Depends On What The Starter Is From. Car Model Engine Size, Or Mounting Bolts Ect. If It Is The Bolts That Assemble The Starter< You Can Get These At A Starter Alternator Shop. The Mounting Bolts. Drop By The Dealer Parts House They Can Fix You Up.
How do you remove the radiator support from a 1991 Acura Integra?
The radiator support on a 1991 Acura Integra is held on with several bolts. Use the appropriate sized socket and loosen all the bolts. Pull off the support.
Where is the starter motor located on a 1995 Acura Integra?
the starter is on transmission's side above the right drive axle It bolts on close to where the transmission bolts to the engine. It's held on by a few bolts and is about the size of a 12 oz pop can. You should be able to see it without getting under the car.
How do you remove the starter on a 92 acura vigor?
To remove the starter on a 1992 Acura Vigor, first disconnect the negative battery terminal to ensure safety. Then, locate the starter, which is typically situated on the engine block near the transmission. Remove the electrical connections and the mounting bolts securing the starter in place. After detaching the starter, you can carefully pull it out from its housing.
How do you remove the distributor rotor from a 1994 Acura Integra?
Remove the bolts that hold the distributor cap onto the distributor. Once this is off the rotor can be reached and replaced on a 1994 Acura Integra.
How do you change a starter in a 01 Acura CL?
1. Disconnect the negative battery cable. 2. Disconnect the starter electrical connectors. 3. Remove the 2 starter mounting bolts. 4. Remove the starter motor. 5. Installation is the reverse of the removal procedure. Tighten the starter motor bolts to 33 ft. lbs. (44 Nm).
Can you use a Acura Integra 1996 gsr distributor on 1996 integra ls motor?
if it looks exactly alike and bolts on exactly the sameway, it will work.
How do you install a front bumper on a Acura Integra?
On my 1990 integra, there are like 5-8 bolts underneath and 1 or 2 on the inside of each wheelwell
