answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How many neutrons are in an atom with z28 A59?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Natural Sciences

What is the symbol for the isotope Z28 A64?

It's Nickel.. 64Ni


What is the fastest Chevy 62?

The fastest Chevy in 1962 was the Bel Air Sport Coupe with the 409 big block mated to a 4 speed manual transmission. This lightweight Chevy was the faster than the Impala and with 409 h.p. was the car to beat in 1962.


What is the horsepowerof a LS1 5.7 liter v8?

The LS1 was introduced in the Corvette in 1997, and made its way into the Trans Am and Camaro in 1998. The Camaro Z28 and Trans am were advertised at 305 hp and the SS and WS6 at 320. Ratings stayed the same until 2001. The 01-02 SS and WS6 models were rated at 325 thanks to an LS6 intake manifold borrowed from the Vette. However a slightly smaller cam was used to keep power at the same level. The fact is an ls1 is an ls1 reguardless of year or model. The SS and WS6 cars will NOT dyno higher than a Z28 or ls1 formula. All 98-02 LS1 cars dyno 280-300 with the A4, and 300-320 with the m6. Forget about the GM ratings. All LS1 cars are good for 350-360BHP. GM underrated these motors in order to keep sales up on the "king of the hill" Corvette.


How do you change the optispark on a 1994 camaro Z28 LT1?

very big job. the water pump must be first removed. you will need a t-8 torx bit for the rotor removal and a e-4 torx socket(reverse torx) drain coolant. remove serpentine belt. you may have to take out the electric fan. I did it without removing it but it was tighter. remove hoses from water pump. disconnect coolant sensor and unclip it from top of water pump. unbolt ignition coil bracket. unbolt and move airinjection pump. remve the 2 bolts holding the air injection pump bracket. remve water pump bolts and then the pump. remove the harmonic balancer pulley keeping note of the position of the arrow on said pulley.remove plug wires. remove the dist cap. remove rotor and replace it with new one in same position. replace with new cap and then reverse steps.