The method of installing screws in a metal roof will vary depending on the type of metal roofing being installed, and the manufacturer who is backing the warranty on said panel.
A list of installation guides for popular panels is found here as examples:
http://www.bestbuymetals.com/how-to-install-metal-roofing.html
Check with the manufacturer of your particular panel type.
it depends on how big the roof is! try putting one every 1 foot. if that doesn't work e-mail me at majj37887@Yahoo.com.
It depends on the type of roofing material. It is best to put them in the ribs but it is acceptable to put them in the flats, usually on 18" centers along each rib.
Yes you can. You will want to cut back any shingles that over hang the edges. Then put 1x4 slats on 19.2" centers parallel to the ridge of the roof make sure to hit the rafters when you nail down the slats. Do not use treated slats as they will react to the metal. Then screw down the metal the the slats.
Can I get help with a metal roof, insulation in walls, siding, & or underpinning on my double wide mobile?
To silence the wind noise on metal roofs
That is what everyone has used for decades.
The roof over the deck is an important addition. There are a few different ways you can design a roof. If you get a metal roof, you need to remember that the sound will be louder if it rains and you are sitting outside, so you might not be able to hear as well. A shingled roof is easier to put on, but sometimes the shingles get damaged in wind storms.
It depends. If you put on a metal roof where you had shingles before and you live in a high hail damage area, the premiums may go up. Typically a new roof will only help, but will not drop the premiums anywhere near the cost of the roof.
take out the two screws on the turn signal lights, the metal strip above the lenses is on a spring hinge. Simply pull the lenses toward you and the metal strip will spring up. Put the new lense in the groove on the metal strip above lense and push back in. Put in your screws for the turn signal light and your all set. Good luck
You can but it is not recommended. The old roofing sheets will promote corrosion under the new sheets. Far better to remove the old corrugated roofing first.
A screw is an inclined plane wrapped around a central axis.It helps to put things together.Some examples are metal screws, wooden screws, jars,bottles and there caps.
The easiest roof to build would be a lean to roof. There are no angles, ridges or gables to deal with.Simply put, it is a flat roof with a slight pitch so water can run off it.Also, many different kinds of materials can be used to actually put on the roof, from pitch and tar to shingles.
Usually not more than two.
I really dont think you can put a roof on your house