Every application is different. Some use shims and others use no shims.
A maximum of three to four shims is recommended.
toyota engines that use 25mm shims 4age 5efe 5sf3 3sfe 2vzfe 7mge 7mgte
Shims are used to fit the upper control arms, the front fenders, the starter and so on. The number of shims varies for each application.
Yes, as a matter of fact it is wise to use cedar shims to install vinyl windows. Using cedar shims can make sure the window stays level, this way, another person can nail the window perfectly in place.
Check the backlash between the starter drive and the ring gear after installation. If it's too tight, use shims.
There are several shims that could be used such as starter shims (for adjusting drive gear to ring gear), caster/camber shims (for front end alignment), body shims (for aligning body panels),
If it has shims now and you buy an OEM replacement starter, then use the shims. If it does not have shims then you will not need them. Replace the starter with an exactly duplicate, installed exactly as the original. If in doubt measure the distance from the mounting plate face to the end of the drive gear shaft and make sure that distance in the same on the replacement starter.
Shims are used to tighten up joints in woodworking. Nails and screws may be used after the shim is in place. For better results, use yellow wood glue.
Ksen Shims is 5' 7 1/2".
You use a feeler gauge and set it to 35 thousands, some clutches need shims while other do not need shims, also you will need an installer depending on the year, make and model.........
Use precision gauge blocks and shims