Want this question answered?
bury screw all the way in and turn out 1.5 to 2.5 turns out
under the carb just ahead of the throttle plate..... 2.5 turns out from lightly seated
NO, a screwdriver is what turns the screw.
The pilot screw setting should be screwed in until it is snug (not tight), then backed out 1 and 3/4 turns.
It should be approximately 2.25 turns out from fully screwed in.
The only setting is one screw on the top of each carb its the mixture screw and should is 1.5 turns out by default.
length of the screw, and number of turns per inch
The pointed end of the idle speed screw should be centered on the idle arm on the carburetor. http://store.chainsawr.com/
Carb. idle screws are set so thew vehicle idles they are not set at a specific number of turns. With the screw turned out but still in the carb start the vehicle. Let it warm up then turn the screw in until the engine will just idle. There are other adjustments that may assist are to the pilot fuel/air screw. This should be screwed all the way in until it lightly bottoms then turned out 2 turns to start. Once the bike is idling per above turning this screw until it idles at the highest point. This should be between 2 and 3 turns out. Readjust the idle screw to the lower idle if needed and you will be ready to go.
Screw both needles all the way in. Small one, screw out 2 1/2 turns. Needle with spring, screw out 3 turns.
two and half turns (so it is 5half turns)
An intruder is someone who butts in where they are not wanted, or someone who breaks into somewhere. Here are some sentences.She came home to find an intruder robbing the place.He felt like an intruder when he discovered his roommate kissing a woman in the living room.Don't be an intruder; if they didn't invite you to the party, you shouldn't try to get in anyway.