0
How many out turns to adjust the idle screw of a rears chainsaw model358.360380?
Wiki User
∙ 14y ago
The pointed end of the idle speed screw should be centered on the idle arm on the carburetor.
http://store.chainsawr.com/
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you adjust idle on poulan wild thing chainsaw?
Use the idle speed adjustment screw to set the idle speed as low as possible without stalling. http://store.chainsawr.com/
How do you adjust idle on Poulan Wild Thing 2375 Chainsaw?
Use the idle speed adjustment screw to set the idle speed as low as possible without stalling. http://store.chainsawr.com/
How do you adjust hi and low settings on a Homelite 330 chainsaw carb?
turn both hi and low fully clockwise till seated. then turn each 1 full turn counterclockwise then adjust your idle speed with idle set screw.
How do you adjust a VW Golf MK1 carburetor?
You can adjust your VW carburetor by using the adjustment screws. There is an adjustment screw to adjust the flow of fuel. There is an adjustment screw to adjust the flow of air.
How do you replace the chainsaw tension screw on a craftsman 20 chainsaw?
Unscrew the adjusting pin. Then pull the screw straight out through the front of the cover. You have to pull hard through the thin, frictiond lock washer. -Scott www.chainsawr.com
How do you adjust the governor on a 504 cummins engine?
On the governor, there is a black plastic cap. Remove cap. Inside is a screw. This screw will will adjust the governor.
Your 92 cr250 idles high how can you adjust this?
You can adjust the idle speed on your 1992 Honda 250, motorcycle with the fuel pump adjustment screw. Turning the adjustment screw will adjust the flow of fuel.
How do you adjust the idle on a 22re Toyota engine?
there is an Allen screw and a nut on the throttle cable you loosen the nut and the screw and adjust it to make it idle up or down.
How do you adjust idle speed on 1983 Monte Carlo?
there is a set screw on the linkage on the carb that will adjust it.
How do you replace the chainsaw tension screw on a STIHL MS250 chainsaw?
My best recommendation is to take it to a certified shop, the tension screw base is located beneath many other adjustments dealing with timing. Tampering with other adjustments may leave your saw non-functional.
How do you adjust idle on 93 maxima?
you can't its computer controlled, unlike the old carburetors with an idle air mixture screw to adjust, its set by the factory and you can't screw with it
Where is the idle adjust screw on a 1994 Toyota 4Runner?
The idle adjust screw is on the throttle body. The side of the throttle body that faces the front of the car should have a dime size flathead screw towards the upper edge.
