Current = voltage/resistance
If those are the only components in the circuit, then
Current = 9/12 = 0.75 Ampere = 750 mA
A battery is rated to supply a certain number of volts. However, it actually supplies less, because they are "lost" as the current has to get out of the battery in the first place.(The battery has internal resistance)The amount of lost volts depends on the current being drawn:The less resistance a circuit has, the more current is drawn, because it's easier to flow.Example:If the circuit has little resistance, it draws a large current and the battery's internal resistance causes more lost volts.If the circuit has high resistance, it draws a small current and there are fewer lost volts.This is why when you short-circuit a battery (give it hardly any resistance to go through) it heats up and may explode. A large current is drawn and all the volts are used by the battery's internal resistance.
The current depends on the total effecvtive resistance of everything connectedacross the battery.If the bulb is the only component there, then the current is E/R = 9/12 = 0.75 amperes.
Use Ohm's Law. Solving for current:I = V/R (current = voltage / resistance)
A resistance of 3 ohms connected between the terminals of a 9-volt battery will result in a current of 3 Amperes. If the battery is one of those little ones with snaps on top, it may be able to produce 3 amperes of current for about 3 seconds before it rolls over and totally dies.
The battery produces a voltage; if a conducting wire - or any circuit for that matter - is connected, a current will flow according to Ohm's Law, that is, the current is calculated as voltage / resistance.
The voltage of the battery, and the resistance of the circuit (including the resistance of the wire and the internal resistance of the battery).
That will depend on the internal resistance of the battery. I = E / R Where I is the current, E is the open circuit battery voltage, and R is the internal resistance of the battery.
Hi, there. A battery is a power supply, a source of potential difference which drives current. In itself, a battery is not a circuit, but if you attach it to a load (a resistance), then a current will form and a circuit is made!
A battery is rated to supply a certain number of volts. However, it actually supplies less, because they are "lost" as the current has to get out of the battery in the first place.(The battery has internal resistance)The amount of lost volts depends on the current being drawn:The less resistance a circuit has, the more current is drawn, because it's easier to flow.Example:If the circuit has little resistance, it draws a large current and the battery's internal resistance causes more lost volts.If the circuit has high resistance, it draws a small current and there are fewer lost volts.This is why when you short-circuit a battery (give it hardly any resistance to go through) it heats up and may explode. A large current is drawn and all the volts are used by the battery's internal resistance.
The resistance of the load is what causes an electric current to flow in a circuit.
The resistance of the load is what causes an electric current to flow in a circuit.
You'd need to know either the resistance or the wattage of the circuit. Ohm's Law: Current = Voltage divided by resistance or Current = Power divided by Voltage
If at battery,parallel circuit shorts then equivalent resistance of circuit becomes approximately 0 Ohms,and therefore as current follows low resistance path infinite amount of current due to low resistance will flow through the wire so,entire parallel circuit will short out,but wire will burn and battery may get damaged. Name:Sumit Karnik.
The current depends on the total effecvtive resistance of everything connectedacross the battery.If the bulb is the only component there, then the current is E/R = 9/12 = 0.75 amperes.
Voltage = (current) x (resistance) Current = (voltage)/(resistance) Resistance = (voltage)/(current)
It depends on the resistance of the circuit, as V=IR, so I=V/R (V=Voltage, I=Current, R=Resistance)
When you add resistance to a circuit, current goes down. Ohm's Law: current = voltage divided by resistance.