10 volts applied to 5 ohms would cause a current flow of 2 amperes.
Current = voltage divided by resistance.
Voltage is equal to the Current multiplied by the Resistance.Without changing the resistance, increasing the applied voltage in a circuit will increase current flow. There is a simple, direct relationship between voltage and current. Double the voltage, twice the current will flow. Triple the voltage, and the current will triple. As voltage (E) equals current (I) times resistance (R), when resistance is fixed, what happens to voltage will happen to current.
The reason an AC voltage applied across a load resistance produces alternating current is because when you have AC voltage you have to have AC current. If DC voltage is applied, DC current is produced.
No, the resistance of a copper conductor does not vary according to applied voltage. It is constant for a given wire size, and only varies with temperature. Of course, current through a conductor causes it to heat, so current, not voltage, indirectlycauses a change in resistance.
V = IR Where, V = voltage I = current R = resistance Thus if resistance is increased with constant voltage current will decrease
Ohm's law: Voltage = Amperes times Resistance. This means that increasing voltage while keeping resistance the same must result in an increase of current.
Resistance is a concept used for DC. the current through a resistance is in phase with the applied voltage Reactance is used for AC the current through a inductive reactance lags the applied voltage by 90 degrees. the current through capacitive reactance leads the applied voltage by 90 degrees. the net reactance is the difference between inductive and capacitive reactance
Voltage is equal to the Current multiplied by the Resistance.Without changing the resistance, increasing the applied voltage in a circuit will increase current flow. There is a simple, direct relationship between voltage and current. Double the voltage, twice the current will flow. Triple the voltage, and the current will triple. As voltage (E) equals current (I) times resistance (R), when resistance is fixed, what happens to voltage will happen to current.
-- Apply a small, known voltage between the terminals of the device. -- Measure the current through the device with the voltage applied. -- Calculate the resistance of the device. It's (voltage) divided by (current).
The amount of current that will pass through a resistance is dependant upon the voltage applied across the resistance. Voltage devided by resistance equals current. This is Ohm's Law.
The reason an AC voltage applied across a load resistance produces alternating current is because when you have AC voltage you have to have AC current. If DC voltage is applied, DC current is produced.
No, the resistance of a copper conductor does not vary according to applied voltage. It is constant for a given wire size, and only varies with temperature. Of course, current through a conductor causes it to heat, so current, not voltage, indirectlycauses a change in resistance.
current depends on applied voltage and resistance.
The voltage applied and the resistance across it.
Inversely. As resistance increases, current dereases; given that the applied voltage is constant.
Voltage / Resistance = Current, you do the math
V = IR Where, V = voltage I = current R = resistance Thus if resistance is increased with constant voltage current will decrease
ratio of ac voltage applied across the diode to the ac current flowing through it