1425 lbs.
The MAP/Boost Sensor of a Cat C7 engine is located on the driver's side of the engine near the back side. It is next to the valve cover in the intake manifold.
The Caterpillar C7 Motor can vary in power from 200hp to 350hp+
A Caterpillar see seven diesel engine will begin to overheat at a water temperature of 210 degrees. The recommended operating water temperature is 180 degrees.
For that model year, options included the Caterpillar C7 or Cummins 6BT /ISB diesel or the 6.8 Ford Triton V10 gas engine.
To run overhead on a c7 Cat engine, you will have to adjust the valves in order to return them to where they should be. In order to do this you will need feeler gauges in order to bring it back to where they were set by the factory.
Well seeing that it is not on the market just yet it's kind of hard to answer that one! However there is a large section devoted to the new C7 and all the speculation that surrounds it.
Cat 3126 torque 780 ft lbs. that is for all cat 3126 c7 engines reguardless of hp rating
A water pump belt can be replaced by removing the old one. The new water pumb belt will be installed in the same way as the old one.
C7 gas is heptane (C7H16).
the c7 is fast as 200 miles per hour
F, Am,Bb,C7,Cm7,C7... Then they repeat
C7 envelopes are 81mm x 114mm.