It varies greatly from product to product and from market
to market. The best way to get an answer is to put an ad on Craigslist
telling what you want installed, ie..
3/4 inch, unfinished oak hardwood over wood subfloor,
new construction, 400 sq feet.
The lesson here is that the more detail you put in the ad, the better the quote.. You will have to understand that not every installer has Golden Hands, some are thieves & butchers, so you may not always want the low bidder..
If the original vinyl floor is still down solid you are supposed to be able to lay another vinyl floor on top. This requires some specific prep work but it can be done. It is a better idea to just remove the vinyl and start with a clean solid surface to apply the new floor. The more layers, the more potential for problems with the layers lifting
R$10 for m2 (US$4)
20 sq. yards is 180 sq. ft. so it will cost you $234.
I paid $9 ft on a guest house that has 900sq ft...live in TX
depends on the thickness of your bedding
depends on the room size
you cut them so they fit
You should not tile on top of a hardwood floor. If you do, it will crack as the wood underneath will expand and contract throughout the seasons. Instead you should be installing on top of some sort of concrete floor. You could either add mud/self leveling mix or cement board. You may also want to remove the hardwood first, if you can.
i guess it means if you are laying floor s down and in your room you have a corner that is ninety degrees, you would be laying down floors in a 90 degree angled area
A hardwood floor can wear down over time, creating lighter colored spots on a floor. A floor refinishing gives new life to hardwood flooring, giving it the same appearance as new flooring. When refinishing a floor, it's important to sand off any existing finish. This can only be done on true hardwood floors - vinyl flooring with a wood veneer will be permanently damaged by sanding. After sanding, lay down a layer of stain on the flooring. Add a layer of polyethylene to protect the wood. Allow the flooring to dry for at least 24 hours, then buff the floor complete the refinishing job.
Lay's chips cost about $2.00 a bag at Walmart but at a bag of Lay's chips at a dollar store is about a $1.00
The cost to lay down a luan sub floor is $15 per sheet, and this would include the material.
5 cent per ounce
Any wood glue will work great for hardwood floors, but make sure it's compatible with your wood type.
Do you mean solid hardwood? You should not install 3/4" solid hardwood directly on top of terrazzo, or concrete or tile. Solid hardwood is supposed to be nailed into 3/4" plywood. Now theoretically, you might be able to add 3/4" plywood in, if you can actually get it into the terrazzo. It is possible (but challenging) to add plywood into concrete using hilties, but it tends to be expensive and time consuming. Also, if you were to add plywood and solid hardwood, you would be raising your floor 1.5 inches. This may cause some height issues, especially for the doors (which might need to be shaved or replaced). If there is kitchen, this could cause height issues with appliances and/or cabinets. However, if you mean an engineered hardwood, it could be floated on top of the terrazzo. You put an underlayment underneath and then install the wood on top. If it is a clickable engineered wood, then you just click it in; if it isn't, then you would glue the joints together.
About $50,000 per mile
get on the floor put your back on it and lay flat with your feet out