i would do it for around 120....depending on it being automatic or stick......around 250 if you had it done at a midas
Yes it is possible with a bellhousing adaptor plate..... but in short no......Buy the right tranny......or a flux capacitor......
If it's the "front seal", meaning the seal on the input shaft, you'll have to separate the engine and trans. Pull one or both to get to the seal.
Replace the chain and both the cam and crankshaft gears.
I need to replace the rack and pinion in a 1993 Nissan Altima.
in the engine compartment on the firewall right in front of the passenger and right behind the coolant bottle.
Remove the screws and pull down on the front portion of the fender liner. This provides just enough room for your hand to reach in and access the two bulb holders. Turn the bulb holder counterclockwise and pull it out of the housing. Pull the bulb from the holder and replace.
On the passenger side, under a cover in front of the door, on the side of footwell
diagram of starter in a 1993 ford probe
Brand New 1993 Ford Probe right off the show room floor cost me "$29 800.00"
very carefully.
on the front of the motor under the front crank it has a plug going to the crank.
4x6 hard to replace!!!