Up to 5 hp. The goal of reboring a block is to eliminate any out-of-round or taper conditions that might exist do to extended use. If the cylinders are round and straight, reboring is not needed.
No two motors have the same exact horse power the only way to find out your motors power is to have it dyno tested.
Not much more than factory h.p. unless you went back with popup pistons after the bore.
Slightly. Adding dome top pistons would increase it more.
What the house power on a 350 bored 40 over rated at
Produce more HP depending on much much they were bored. The engine can generally be bored up to .060 over in most cases.
From the factory the GS700 had 80 hp, but over time, some of that will be lost.
.80 mm then you need to replate it
A 350 bored 40 over is a automobile engine which has had its displacement increased to 383 cubic inches. This results in more power without needing to purchase a new engine.
Up to 60 over but I personally wouldn't go past 40 if u plan to run any kind of horse power. Make sure u can buy 60 over pistons before any bore is done
Over 9000
When horses are bored there are several behaviors they can exibit. Some horses pace constantly in their stall or in the paddock. Some stamp their feet or paw the ground. They will also chew on things like fencing or stall boards. If a horse is extremely bored it may crib. Cribbing is when the horse bites onto something such as a stall board or a section of fencing and sucks in air. It will do this over and over for hours. If a horse is cribbing it is a sign of extreme bordom and is a dangerous behavior to the horses health as it can lead to colic and gas issues. It is also a contagious behavior which other bored horses can learn. Is it best to not stable a cribber where other horses can observe the behavior.
A horse actually is stronger than one horse power: 14.9hp is the amount of power an ACTUAL horse produces, but over longer periods of time, the average horse produces less than one hp (about 0.7 hp on average).