It should be making around 84hp and 103 ft*lb of tq.
I used to have an 87 230 quadsport i had it jetted alittle and it did 69 mph on tar. Other than being jetted it was stock.
It will gain about 2 to 3 horsepower when jetted
I have a M109R with Cobra Exhaust, Dyno'd and Jetted and Tuned, 137hp. Thanks.
stock horsepower is right around 32..... piped,jetted,wit airbox lid off right around 42 www.gtthunder.com dyno sheet for yfz
stock horsepower is right around 32..... piped,jetted,wit airbox lid off right around 42 www.gtthunder.com dyno sheet for yfz
Have the lines water Jetted to scour them properly and get rid of years of crud build up
faster than stock it all depends on the gearing if you dont upgrade your gears it will just gain in horsepower and it will have better acceleration but if you do upgrade the gears it would go about 85 and up
if not all ready done get it de- restricted, then you could get a race exhaust for it e.g. technigas, scr, Leo Vince. then you could get it up jetted and get an air filter on it .
To increase horsepower. However, adding a less restrictive air filter will require other modifications in late model motorcycles. You will also need to add a less restrictive muffler and the carburetors will need to be "re-jetted". By simply adding a less restrictive air filter and not doing the rest of these modification you may actually cause more harm than good. Your motorcycle was tuned at the factory using the components as is. When you change one component it affects the performance of the others.
Put a new pipe on it, a good high flow filter with a pre filter. Run no air box lid and have it jetted (assuming it is not EFI). You could also change your gearing. If you add teeth to the front and/or put a smaller sprocket on the back you will have more top end.
yes but it dosn't make the performance any better because it is already jetted. if you are wanting it to go faster stick a polini variator and a gear up kit in then you will be shiffting pretty quick.
Mine is not making the croaking sounds BUT thank you for asking WHY is "YOUR" sink=The reason mine does not make that sound is my venting is working properly and the drain lines have been water jetted a few years ago to establish full flow=