Drain the oil. Take the bolts out of the oil pan. Hold the oil pan from underneath and tap both sides with a rubber mallet. It may take some force to break the seal with the gasket and silicone. Also, if it's a 4x4, you may have to unbolt the engine from the engine mounts and jack the engine up from the crankshaft pulley. after the oil pan is out of the way... look up into the engine. You will seel the oil pump toward the back and it should be easy to unbolt.
Depends on the labor per hour in your area.
Depending on brand-200-260.00. They are not hard to install, but if you pay labor on an install it would be 200-600, depending on shop.
I just got a quote of $200 for a 98 expedition with me furnishing the pump
how much labor time does it take to change the water pump on an 07 impala
I was quoted $2200 to replace the timing belt for the amount of work and labor involved.
To replace the circulating pump it will cost between $150 and $300 depending on the hot water heater. It will also cost you labor fees if you have someone install it for you.
Depends on locality, but in the Midwest (Iowa) around 60 bucks an hour. @ about 2 hours or?
The pump itself should not be much money ($15-$25) It's the labor that kills you. I had it replaced on my pathfinder and the it took about 4 hours so the labor alone was nearly $300. If your water pump is not hard to get to it may be less.
fuel pump is about 350 and about 4hrs labor
Yes you can! Make sure the pump you buy has the same psi your truck needs. By DEREK DAVIS
Should be about 3 hours labor.
between $30-$70