0
take out the plug and fill it till it comes back out the fill hole
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How much transmission fluid does a 1987 Jeep Comanche hold 4.0 straight six automatic?
4 qts.
How hot does exhaust manifold get jeep Comanche?
my exhuast is broke jb weld will hold to 600 degrees so will the exhaust get to hot
How much fuel does 1988 Jeep Grand Wagoneer hold?
20 gal
Is there inner c clips that hold in the rear end axle on a 2003 jeep grand Cherokee?
No, you remove the 4 nuts on the outside, and pull the axle shaft out with a slide hammer.
Where is the low pressure air conditioner charge fitting located for a 1992 Jeep Comanche Is it the upper or lower fitting behind compressor?
The low pressure side of most cars is the larger of the 2 lines. This should hold true for the Comanche as well.
How do you change a crank sensor on a 1988 Jeep Comanche?
Crankshaft Sensor is located at back of engine near the flywheel. Two bolts hold it on and there is a connector with two wires. CPS cost approx. $30. Screw out 2 bolts, undo connector and pull out of engine block. Their may also be a dust cover and shims. Enjoy.
Where can you find a wheel and axle on a fan?
you will find a wheel and axle on the back of the because the axle will hold the axle and the axle makes the fan move :)
Is a crank a wheel and axle?
Yes It is. The wheel is where you hold and the axle is the part where it is conected to the object.
Did the Comanche have any special ceremonies?
Each July in Walters, Oklahoma, the Comanche people powwow to celebrate their culture and heritage by singing, dancing, and socializing. In September, they hold a Comanche Nation Fair. Their website is listed below:
How much can a split axle tractor trailer hold on the back axle?
A ten foot spread axle trailer is allowed 20,000 lbs. per axle, for a total of 40,000 lbs.
What could be wrong if your 1988 Jeep Comanche will not turn to the left after you have replaced the power steering pump and gear box?
The pitman shaft needs to be in the center of its rotation and the wheels straight ahead before connecting the pitman arm to the pitman shaft. And be sure to hold the arm solid by one means or another when applying the 185 ft-lb of torque to the pitman arm nut, otherwise, no promises about what damage will be done to the gearbox.
How many yards will a quad axle hold?
25-28
