0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the fuel pressure regulator located on a 2002 Monte Carlo?
Fuel pressure regulator is on the top of the motor above the end of the valve cover on the driver side of car.It is round about 1 1/2'' tall and has a vaccum line coming out the top.
Where is the fuel filter on a 350 engine for a Chevy Monte Carlo?
inside the carb behind the fuel line the biger of the two nuts
Where is the fuel filter located in a 1981 Monte Carlo?
In the carb. housing where the line enters. Take the line out and there is your filter paper,or composite.
How do you depressurize the fuel system on a 2000 Monte Carlo SS?
Open the hood and locate the fuel lines on the engine, on the larger fuel line you will find a shcrader valve that is where the pressure is tested with a fuel pressure gauge. push the pin down to relieve the fuel pressure. Do this with the keys in your poc ket ,not in the ignition switch. key MUST BE OFF.
1998 Monte Carlo fuel relay switch My fuel pump is not getting any fuel to the fuel pump. So far I have found 2 vacuum leaks. When I remove the cap at the end of the fuel line there is no hissing?
on a 1998 chevy monte carlio i have a problem the engine start but cut off and i chech the fuel line coming from the pump and the pump pumping fuel but low pressure is this mean the pump is bad?
Where is fuel filter on 84 Monte Carlo ss?
look at the back or front of the gas tank, just follow the gas line out of the tank and you will run into it.
How do you replace the fuel filter on a Chevrolet Monte Carlo?
Releave the fuel pressure from the fuel rail schrader valve. Jack up the car and do NOT use cinder blocks. On the driver's side frame just forward of the gas tank is the fuel filter. It will require a special tool to disconnect the fuel line from the filter. Remove the filter from the bracket and install the new one. Cycle the key several times to pressure up the system. jd
Where is fuel filter on a 2004 Monte Carlo?
Fuel filter is located along the frame just below the drivers side door. Should be a silver cylinder with lines coming out both sides. One line runs from fuel pump through the filter the other line runs to the injectors
Where is the location of the fuel filter on a 1998 Chevrolet Monte Carlo?
The fuel filter is located under the car on the frame on the driver's side and just forward of the gas tank. You will have to releave the fuel pressure at the fuel rail. Then the car will have to be jacked up. Do NOT use cinder blocks. It will require a special tool to remove the fuel line from the filter. Remove the filter from the holder and install the new filter. You will need to cycle the key several times to pressure up the system. jd
How do you change fuel filter on a 2000 Chevy Monte Carlo?
You'll have to drop the fuel tank and on the top you'll see where the pump is. Pull the pump and the filter is on it. If there is another filter somewhere else besides the one on top of the fuel tank (some vehicles do have more than one) then just trace the fuel line back and the other one will be about 3 foot down the line on the frame. Above answer is wrong!! The fuel filter for a 2000 - 2007 Monte Carlo is just in front of the rear driver side tire and the fuel pump can be accessed through a panel in the trunk just behind the rear seats
How do you change fuel pump on a 2001 Chevy Monte Carlo?
You can either drop the tank and use a pair of snap ring pliers to remove the pump and sending unit. Or you can remove the bottom part of the back seat and the trunk liner and get to it that way. Either way make sure you relieve the pressure on the system first by taking off the fuel filler cap(where you put the gas in) and bleed the fuel line off of the pressure regulator located near the fuel rail under the hood.
Where is the fuel filter located on a 1979 Chevy Monte Carlo?
Those are usually in the carb. You would need to disconnect the fuel line and remove the threaded fitting. Pay particular attention to the orientation of the filter and the spring to install the new one in exactly the same way.
