0
How much to repair torque converter for 2001 Oldsmobile aurora?
Wiki User
∙ 10y ago
you do not repair a torque converter. you replace it with a new one. and, it's gonna cost you. about a grand . easy.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Is a torque converter major repair?
It would be considered a major repair only because of the time involved to replace it. The transmission must be removed to access the torque converter.
How do repair code P0740?
Usually you replace the torque converter.
How do you repair code P0740 on a Chrysler town and country?
P0740 Torque Converter Clutch Circuit Malfunction The torque converter will need replaced.
How to replace torque converter seal on legacy?
Any torque converter repair whether it be a seal or whatever must be made with the transmission out of the vehicle and the torque converter pulled off the front shaft to gain access to the seal.
On a 93 Oldsmobile Cutless Cierra the lockup torque converter doesn't work Why?
low fluid level
What are the torque specs for Oldsmobile aurora front hub bearing?
160Nm (118 lb. ft.) according to the service manual.
Car cuts off when in gear?
If the car has an automatic transmission, then it might have lock up torque converter. If the torque converter is engaged while the engine is at idle, then the engine will stall. Bring the vehicle to reputable transmission repair facility and have the replace the torque converter clutch solenoid.
Where is the TCC located on your 2001 dodge Dakota vehicle?
The torque converter clutch is inside the torque converter.The torque converter clutch is inside the torque converter.
How do you remove the torque converter on a 1999 Chevrolet Silverado?
You will have to remove the transmission. That is not a job for a novice. You need to take it to a repair shop and let them diagnosis and repair it.
Where is the torque converter on a 1999 Buick Le Sabre?
The torque converter is between the engine and transmission.The torque converter is between the engine and transmission.
How does a torque converter amplify the torque?
The stator inside the torque converter directs the fluid at an angle to trans. part of the torque converter amplifying the force on the vanes.
What is repair procedure for transmission locking up when stopping could it be the torque converter locking up?
yes torque converter is locking up just unplug the wire that goes into convter it will disconect overdive but it will run better imediently
