0
What else can I help you with?
Where is the front seal on a transmission for a 1994 Chevy blazer s10?
The front seal on your automatic transmission would be between the torque converter and the front pump of the transmission. The transmission would have to be removed along with the torque converter to replace the seal.
Where can you find the transmission front seal on a 1999 Chrysler town and country?
Not sure what you are asking, the front seal is what the torque converter slides into.Not sure what you are asking, the front seal is what the torque converter slides into.
Do you have to remove the transmission in a 92 aerostar awd with a a4ld transmission the van to replace the leaky front seal?
yes , because the seal is behind the torque converter
How do you change the front transmission seal on a 1991 Chevy Camaro?
You will have to remove the transmission and torque converter from the car to get to the front seal.
How hard is it to replace the torque converter seal on a 1986 ford ranger 4x4?
All you have to do is take the tranny out and unbolt it from the fly wheel, its really easy, I have done it a few times.
Leak in the front seal of the transmission on your 92 z 71 what do you do?
if the seal is really leaking, you will have to pull the transmission to replace it. if it's a standard, just pull the tranny, pry out old seal, and use something the same size as new seal to drive it in square. if automatic, then you have to take torque converter off the input shaft to replace seal. make sure when you replace converter to push in on it while rotating it.it has to be seated all the way in or you will bust the pump. usually 3 notches, maybe four.
How do you remove the transmission from a 2000 Chrysler Cirrus with 6 cylinder engine?
was wondering if someone can tell me how in detail to remove the tranny from my 1997 chrysler cirrus i need to replace the torque converter seal
Toyota Motor Manufacturing Canada Should I have to have the seals replaced on the torque converter and the main seals replaced when there is little or no oil leak and the dipstick reads over full?
Toyota's are very good about not leaking. Unless you have the transmission out there is no need to replace the torque converter seal. The rear main very rarely ever leaks.
How many hours does take to change the torque converter seal?
Changing a torque converter seal typically takes about 3 to 5 hours, depending on the vehicle make and model, as well as the mechanic's experience. The process involves draining the transmission fluid, removing the transmission or torque converter, and replacing the seal. Additional time may be required if there are complications or if other components need attention during the repair. Always consult a service manual for specific guidelines related to your vehicle.
How Do you Replace Front Seal On Transmission 92 Aerostar?
To replace the front seal on a 1992 Ford Aerostar transmission, first ensure the vehicle is securely lifted and supported. Remove the transmission pan and drain the fluid, then detach the torque converter from the flex plate. Carefully pull the transmission from the engine and remove the old front seal using a seal puller. Install the new seal, reassemble the transmission, and refill it with fluid before reconnecting everything.
94 dodge caravan trans fluid leaks out of bell housing is that the torque converter seal?
It could be. It could also be a pump seal failure, or a crack in the trans case.
What causes your 92 s-10 to leak near torque converter?
Oil or tranny fluid? Oil- engine rear main seal. Tranny- Input shaft seal
