If the ballast on a fluorescent light blows the lamp will not work.
a compact electronic ballast in the base of the lamp
Fluorescent light replacement is easy as replacing light bulbs. Slowly twist the fluorescent until the lead of each end aligned to the path of ejection/insertion. Or just simply stretch both end of fluorescent ballast then remove/insert the fluorescent light.
Depends if ballast is in fixture and switch is on. Several watts if new ballast and perhaps 15 watts for old ballasts....
A HID ballast can be purchased from Amazon or eBay. The term 'ballast' is used to describe large inductors used to limit AC current for fluorescent lighting.
you need to replace a ballast
If the ballast on a fluorescent light blows the lamp will not work.
These tubes need a ballast to operate the tubes. The current and voltage will be marked on the fixtures ballast.
a compact electronic ballast in the base of the lamp
Fluorescent light replacement is easy as replacing light bulbs. Slowly twist the fluorescent until the lead of each end aligned to the path of ejection/insertion. Or just simply stretch both end of fluorescent ballast then remove/insert the fluorescent light.
Depends if ballast is in fixture and switch is on. Several watts if new ballast and perhaps 15 watts for old ballasts....
A HID ballast can be purchased from Amazon or eBay. The term 'ballast' is used to describe large inductors used to limit AC current for fluorescent lighting.
No, the ballast's output is not matched to operate a fluorescent bulb.
In colder climates a special ballast and lamps have to be used. These are known as cold start ballasts. The cost is much greater using fluorescent fixtures than HID fixtures and the light output is much less.
Normally its the ballast that's different. Use an electronic ballast rather than a magnetic.
"Compact fluorescent lamps" (or, more commonly CFLs) sold direct to consumers for installation in a standard screw-in socket have an integral ballast built into the base. The ballast converts and controls the line voltage from the socket to properly drive the fluorescent lamp. Ballasts are generally fairly complex circuitry. All fluorescent lamps require a ballast. However, most lamps used commercially ("ordinary fluorescent lamps") do not have the ballasts built into them; rather, the ballasts are hidden somewhere in the fixture.
For information about fluorescent tube lights see the answers to the Related questions and the Related link shown below.