0
It would depend on the make and type of engine
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Head gasket torque specs 4.3 Chevy astro?
The 4.3 liter Chevy Astro head gasket torque specification is 160 pounds. The head gasket bolts should be torqued in 40 pound intervals.
Head gasket bolt torque specs for a Mazda mx3?
What are the head bolt torque specs for a mazda mx3 1600
What are torque specs for head gasket and intake manifold for 1999 Pontiac sunfire?
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
What is the cylinder head torque and sequence on a 585 case tractor?
What is the torque specs on a 585 case ln tractor head gasket
Why torque and then back off and then re torque metal head gasket?
That method results in a more accurate and even torque.
What is the Vmax head gasket torque specs?
Cylinder head 43Nm Cylinder head cover 10Nm
Head gasket torque specs for a 2000 Pontiac sunfire 2.2L?
The short bolt torque specs for the head gasket of a 2000 Pontiac Sunfire is 43 foot pounds. The torque specs for long bolts is 46 foot pounds.
How do you Run in a head gasket?
to RUN in a head gasket,u torque the head bolts to specs.you then run engine for specified amount of time, then again torque head bolts to specs. most shop manuels will give you 2 toque settings.
What is the torque spec for a 2.5 Mitsubishi head gasket?
115 - 125
How much pressure do the nuts need on the head gasket?
The FINAL torque value should be 78 foot-pounds, but the tightening process goes in 3 stages. I don't recall off the top of my head just what the torque values are for the first and second stages.
Riding mower Briggs and stratton blowing out oil?
The most common place for oil leaks is the sump/crankcase cover gasket. A torn gasket will allow oil to escape. A common cause could be a blown head gasket putting too much pressure in the crankcase.
How do you know if the problem is the thermostat or a blown head gasket?
perform a pressure test on the cylinders. if they don't hold pressure it's a blown head gasket
