25 ft lbs, 50 ft lbs, 50ft lbs, 90 deg turn.
The 1999 Dodge 3.3 liter cylinder head bolts should be torqued at 160 pounds psi. The head bolts should be torqued in 40 pound intervals.
You should torque the head bolts by alternating from and to end, working towards the center. The head bolts should be torqued in 40 pound intervals.
Torque specs can be found in the Haynes Auto Manual.
three steps 65
You risk breaking the bolts, or crushing the gasket to the point where it will not seal.
The torque specs for a Toyota Camry cylinder head is 60 pounds for the inside bolts and 50 pounds for the site bolts. The cylinder head bolts should be tight from and to end alternating.
The cylinder head bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.
The head bolt torque for the Dodge 6 cylinder and V-8 engines is 50 ft. lbs. torque. If it is a diesel engine, the torque is 90.4 ft. lbs. Tighten the bolts by working from the center out, and alternating side to side. This prevents warping of the head.
Torque wrench,90 ft.pounds
on my '03' 125SX the head bolts should be 18nm.
if your cylinder head is made out of aluminum ,i would say to re-torque the head.the bolts holding the head down get lengthened by the head expanding faster than the bolts.
The 3800 Pontiac engine had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.