Want this question answered?
external conditions such as increase in ambient temperature reduces the power output of a gas turbine
area is a way of measuring size. So a larger area should increase the power output
The input of a load cell is the force or weight applied to it. The output of a load cell is an electrical signal, typically in the form of voltage or current, that is proportional to the applied force or weight.
The bandwidth of a circuit, amplifier etc has been chosen to be defined by the points when the power output falls to half its maximum. Log 0.5 is -0.3 which in the decibel notation is -3dB (-0.3 Bels= -3 decibels). When the output power is at 0.5 maximum, then since the power varies as the square of the voltage, the output voltage is 0.707 of the maximum output voltage.
A: It is a transformer that has one or more leads wire output so switch can be used to change the output voltage from a reference wire.
The effect of diode voltage drop as the output voltage is that the input voltage will not be totally transferred to the output because power loss in the diode . The output voltage will then be given by: vout=(vin)-(the diode voltage drop).
No. There are several factors that may affect the output voltage. For instance: Resistors, Transformer, Voltage regulators and others that can control the output voltage to a certain level.
Output of the alternator is controlled by the voltage regulator.
By using something called a voltage divider.
The ratio of output windings to input windings determines the ratio of output voltage to input voltage. The ratio of current is the inverse.
self sustaining speed is output of a turbine= input into compressor
Build voltage followers, one for each engine. Feed the control signal into the voltage followers.
Rectifiers don't "stabilize the output voltage" of rectifier circuits when input voltage fluctuates. The rectifiers just rectify the input, and the output will fluctuate as the input does. Another form of "conditioning" of the rectified output is needed to address the issue of fluctuations. And we use the term regulation to talk about the effect of "stabilizing" an output voltage. Through regulation, the output will be resistant to changes in voltage when changes in the input voltage occur.
Generator output is controlled by voltage feedback to the voltage regulator which senses voltage drop or rise and regulates the current being sent to the armature. This rise and fall of the armature current governs the generators output voltage.
If you mean how to you wire together two or more wind turbines together before the they reach the charge controller then you have problems: 1) The voltage is AC so you either need to phase the AC output together, and feed that output into the charge controller, or 2) You rectify each output to DC (using diodes) and equalize the voltages from each before they go into the charge controller. If you do not equalize then the current from the turbine with the lower voltage could be blocked by its own rectifying diodes. Do not remove these diodes either as one could end up driving the other turbine. 3) Use a separate charge controller for each turbine then wire together downstream. Does anyone else have any better ideas?
Voltage gain is the ratio of the output voltage of an amplifier to its input voltage.
Output voltage will be .5v to 4.5v