The average shop rate for work is about $80/hr. The entire halfshaft is replaced not just the joint. and those will run around 100 dollars. If I had to give you a ballpark without looking at a labor book for the vehicle I would say roughly 300-400 USD.
1997 Honda accord special addition
The 2001 Honda Accord lower ball joint torque specification is 90 pounds. The lower ball joint should be torqued in 45 pound intervals.
702.98
32 mm
take it to the shop!
The left CV joint can be replaced on a 1989 Honda Accord by removing the left tire and the moving the brake lines. Next, the ball joint and the tie rod should be removed, which will allow for their to be enough room to use a pry bar against the transmission which will pop out the CV joint.
the loud clicking noise might possibly be a bad cv joint if so get repaired asap i just had the same problem fixed in a couple hours
Changing the struts on a 2000 Honda Accord requires removing the lower control arm, ball joint, and strut mounts. An alignment is suggested after installing new struts to provide the best drivability.
You have to take the control arm and ball joint to a shop and have them pressed together, otherwise it is easier to buy the new control arm with the ball joint already in it.
the fixed the fixed
A fixed joint is a joint between two bones that doesn'tmove.
A fixed joint is a joint between two bones that doesn'tmove.