0
What is the torque specification for the lower ball joint on a 2001 Honda accord dx?
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How to change cv joint on 97 Honda Accord lx?
1997 Honda accord special addition
What is the size of a 1998 Honda accord cv joint nut?
32 mm
How do you replace a fuel joint hose in a 1992 Honda accord lx?
take it to the shop!
How do you Replace the left cv joint on a 1989 Honda Accord?
The left CV joint can be replaced on a 1989 Honda Accord by removing the left tire and the moving the brake lines. Next, the ball joint and the tie rod should be removed, which will allow for their to be enough room to use a pry bar against the transmission which will pop out the CV joint.
How do you replace axles 1991 Honda Accord AT?
Support vehicle properly on jack stands. Remove both front wheels. Remove lower ball joint nut and cotter pin. Remove axle nut (36MM). Seperate lower ball joint carefully. Pull axle from housing and from transmission. Reassemble in reverse order. Torque Axle nut to 105 ft./lbs Install new cotter pin in lower ball joint after tightening nut. Torque wheels to 80 ft.lbs. Drive away a happy Honda owner.
What is involved in changing the struts on a 2000 Honda accord?
Changing the struts on a 2000 Honda Accord requires removing the lower control arm, ball joint, and strut mounts. An alignment is suggested after installing new struts to provide the best drivability.
How do you replace an upper ball joint on a 1994 Honda accord ex?
You have to take the control arm and ball joint to a shop and have them pressed together, otherwise it is easier to buy the new control arm with the ball joint already in it.
Vibration on 1988 Honda accord when in drive?
if the vibration is on acell it could be a bad inner cv joint. if it is a freeway speeds it could be a wheel out of balance. if it there when your braking it could be a warp brake rotor.
Is the torque increased decreased or constant on a universal joint?
is the torque increased decreased or constant
What makes the front right tire on 1986 Honda accord pop and creak when you turn or go over bumps?
The CV joint has gone bad. You can purchase a rebuilt drive axle and CV joint on eBay for $49.00. I would recommend changing them both at the same time.
Which series you joint has the greatest torque capacity?
1480
How do you change the rubber jacket covering the front wheel bearing on a Honda Accord wagon?
This rubber jacket you speak of is actually covering the CV joint. If the rubber is torn or cracked, then you more than likely need to have the CV joint replaced, as it will fail due to exposure to water and road debris. The rubber boot is what protects the joint.
