on the valve cover the bolts going around the edges of the cover all need to come off. be careful in that some of the bolts may be longer than others. i have found if u let the vehicle sit for a little bit and let the oil drain back into the oil pan there is no mess involved. take the cover off and you'll have to get all of the old gasket off of both the bottomside of the cover and where the cover goes on. i usually use a razor blade for this. scrape towards the outside to keep gasket matter from getting into the springs ,or cover all of them with rags. put the new gasket on the cover .i use silicone to keep it from moving around when lining it back up.check the torque specs for the bolts when putting it back on .
dosent make sence because its the same car
how do you replace the valve cover gasket on a 2002 mitubishi lancer
The valve cover gasket, on a 2004 Jeep liberty, can be found by removing the valve cover. Peel the gasket off of the head and replace with a new gasket.
What is a oil cover
The valve cover ask it, on a S 40 Volvo, can be replaced by first removing the valve cover. Remove the old gasket and replace with a new gasket.
More than likely you have a valve cover leak. You probably need to replace the gasket(s).
Tighten each one uniformly just until they stop, any further and you squeeze out the gasket, any less and it leaks.
simply remove the valve cover gasket,take the old one off,clean the area well, and replace the gasket,tighten the cover evenly.(if ur gasket is made of corque take care not to break the gasket
How do you replace a broken tail light cover for a 2005 Nissan Pathfinder ?
how to replace valve cover gasket toyota rav4 2001
how do you change valve cover gasket 2004 hyundai elantra
How much does it cost parts and labor to replace a valve cover gasket on a 1990 Honda Accord 4door.