I've added a link below called "96+ Water Pump Replacement Procedure." It's a link to the replacement procedure with pictures.
1)Drain the coolant.
2)Remove the shroud: 7 - 10mm bolts
3)Remove the fan and clutch: There is no need to separate the fan from the clutch. The whole thing threads on to the end of the water pump. Turning counterclockwise removes the fan, clockwise tightens it back on (from the point of view of standing at the front of the vehicle facing the engine compartment). I don't know the size, because rather than break out all my wrenches, I just grabbed an 18 inch crescent wrench. Place the wrench on the nut and tap loose with a hammer. The tapping will break it loose. You have to tap it, if you just try to loosen it, the belt won't hold it and the whole thing will turn. After it breaks loose just spin it off.
4)Break loose the bolts holding the pulley on: 4- 13 mm or 1/2" bolts. Just break them loose, don't remove them.
5) Remove the serpentine belt.
6) Remove the pulley: Finish removing the bolts holding the pulley and remove the pulley.
7) Disconnect the hoses.
8) Remove the old pump: 4-14 mm or 9/16" bolts.
9) Clean the surface: Remove all traces of the old gasket.
10) Install new pump: Apply a bead of blue Permatex around the holes on both sides of the gaskets, put them on the pump and insert the bolts through the holes to hold the gaskets in place. Carefully lower the pump in to position. Thread the bolts into the block and snug them. Then remove the bolts one at a time, add the permatex to the threads, and then reinsert. (only do one at a time so that the pump doesn't shift and disturb the mating surfaces) Then tighten all the bolts.
11) Reinstall everything in reverse.
There will be a lot of air trapped in the system, so after you fill it, get the engine to operating temperature, shut it off, let it cool, then add more. The air trapped in the system can cause your engine to over heat if left unattended. I suggest filling the system with water only and run it like that for a day or two just to make sure there are no leaks. That way you don't waste your antifreeze if you have to do further repairs.
where is the blower motor on a 2001 chevy blazer
Windshield
Yes, the doors from a 98 Chevy Blazer will fit a 2001 Chevy Blazer with a little moderation.
You can replace the rear vent window on a 2001 Chevy Blazer LS 4x4, 2 door with Direct Fit Power Window Regulators.
When it gives you trouble otherwise, leave it alone.
will a 245x75x15 fix a 2001 chevy blazer 2dr
my Chevy blazer 2001 4 door has 6 speakers
unplug old one install new one
how much u think auto zone or pepboys will charge me to fixa head gasket on a chevy blazer 1996
wat other motor can i put in my 2001 chevy blazer
How to Remove the Steering wheel From a Chevy Blazer 2001
how do i replace a heater core in a 2001 Chevrolet blazer